Goal Zero Crush Light User manual

Type
User manual
1
Table of Contents
Get To Know Your Gear 2
How It Works 3
Recharge Your Crush Light Lantern 4
Technical Specifications 5
Français 6
Deutsch 10
Español 14
日本語
18
BEFORE FIRST USE:
Take the Crush Light Chroma out of DEMO mode
by pressing the on/off button for 10 seconds.
2 3
GET TO KNOW YOUR GEAR HOW IT WORKS
Micro USB Input
Removable Hanger
Solar Panel
On/Off Button
Rechargeable
by Sun
RUNTIME LUMENS CHARGE TIME
High 3 hours 60 lumens USB source 3.5 hours
Medium 6 hours 25 lumens Built-in panel 20 hours
Low 35 hours 6 lumens
Candle Flicker 3.5 hours
Hour Runtime
on Lowest
Setting
TIP:
Fully charge the crush light before its first use.
3 WHITE MODES + CANDLE FLICKER.
Push the On/Off Button to select brightness modes.
Press 1X for High
Press 2X for Medium
Press 3X for Low
Press and hold for 2 seconds for candle flicker
Press and hold for 3 seconds to turn it off
Still in DEMO MODE? See the front cover for instructions.
USB
Rechargeable
Weatherproof
IPX4 Rated
4
TECHNICAL SPECIFICATIONS
Recharge from USB or solar panel.
RECHARGE YOUR CRUSH LIGHT LANTERN
5
2.5 Hrs
USB Port
20 Hrs
Full Sun
Goal Zero Crush
Light Lantern
Built-in
Solar Panel
Know it’s charging with the LED indicator light next to the
charging port turns red. The Crush Light is fully charged when
the light turns green.
LED Indicator
Micro USB Input
Helpful Recharging Hint:
Place your Crush Light so the solar panel is directly angled at
the sun. For the best charge, reposition it throughout the day
so it stays at the best angle.
Battery
Cell chemistry
Li-ion Polymer
Cell capacity
1.85Wh (3.7V, 500mAh)
Lifecycles
Hundreds of cycles
Shelf-life
Charge every 3-6 months
Solar
Rated Power
~0.12W
Cell type
Monocrystalline
Ports
USB port (input)
5V, up to 0.5A (2.5W max)
General
Durability
IPX4
Weight
3.2oz (91g)
Dimensions (Open)
4.95 x 4.95 x 3.9in (125 x 125 x 100mm)
Dimensions (Closed)
4.95 x 4.95 x 0.6in (125 x 125 x 15mm)
Operating usage temp.
32-104 F (0-40 C)
Certs
Warranty
12 months
Be sure to activate your warranty at goalzero.com/warranty
JG030518V1
GOAL ZERO HEADQUARTERS
675 West 14600 South
Bluffdale, UT 84065
1-888-794-6250
Designed in the U.S.A.
Made in China
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13

Goal Zero Crush Light User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI