Lopi 1250i Wood Insert User manual

Type
User manual

This manual is also suitable for

Lopi Front Blower
Installation Instructions
Page 1 of 2 17601771.docx — 11/15/12 © Travis Industries, Inc.
Compatibility
SKU99000123Answer,Revere,1750Insert,1250Insert
SKU99000126Freedom
Items Required
3/8”Nutdriver
PhillipsScrewdriver
SlipJointPliers(ifswitchingpowercordtoleftside)
To Switch the Power Cord to the Left Side:
Useapairofslipjointplierstodisconnectthestrainreliefwhichholdsthepowercordinplace.Withthe
powercordslackened,theMolexconnectorsthatattachthepowercordtotheblowerassemblymaybe
disconnected.Prythebuttonplugfromtheleftsideoftheblowerassembly
andinsertitintothehole
ontherightside.PulltheleftsideMolexconnectoroutfrombehindthedeflectionpla teandcutthe
nylontiethatholdsthewireback.InserttheMolexconnectoronthepowercordthroughtheholeon
theleftsideoftheblower
assemblyandattachittotheleftsideMolexconnecto r.Routethewire
directlybehindtheblowercage.Placethestrainreliefoverthepo wercord(itshouldbeinthesame
locationonthepowercordasbeforeapproximately2”fromwherethewiressplit).Insertthestrain
relief
intotheholeontheleftsideuntilthestrainrelieflocksinplace.Makesurethepowercord,wires,
orMolexassemblydonotprotrudeintothebloweropening.

Lopi Front Blower
Installation Instructions
Page 2 of 2 17601771.docx — 11/15/12 © Travis Industries, Inc.
Installation
1. Attachtheblowerfollowingtheinstructionsbelow.
NOTE:Beforetighteningthescrewswitha3/8”nutdriver,lift theblowerupsoittucks
underneaththeashlip.
2. Plugthepowercordrunningfromthecontrolboxintoagrounded110voltelectricaloutlet.
Blower Operation
Theblowerwillnotstartuntiltheapplianceisuptotemperature,activatingathermodiskwhichthen
allowspowertothemotors.Onceuptotemperature,theblowerwilloperateatthespeeddetermined
bythepositionoftheblowerknob(seetheillustrationbelow).Theblowerwillshutoffautomatically
oncetheappliancecools.
Use a 3/8" nutdriver to secure the
front blower to the appliance.
Plug the
blower into a
110 volt
grounded
outlet.
3/8" Nutdriver
Remove the two screws.
Phillips
Screwdriver
Remove the rheostat plate to access the
blower mounting holes (leave the wiring
intact). Re-attach the rheostat plate after the
blower is attached.
OFF
Turn the dial all the
way counter-clockwise
until it clicks off.
HIGH
The high position is all the
way counter-clockwise,
without clicking off.
LOW
Turn the dial all
the way
clockwise.
  • Page 1 1
  • Page 2 2

Lopi 1250i Wood Insert User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI