2. Dacor
  3. AEHK2CP

Dacor AEHK2CP Installation Instructions EH_EHR_MH Baffle Installs [426 KB]

  • Hello! I am an AI chatbot trained to assist you with the Dacor AEHK2CP Installation Instructions EH_EHR_MH Baffle Installs [426 KB]. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Bafe Installation
The filters are located on the bottom of the hood,
directly above the cooking surface.
STEP 1: Start by removing the existing lters.
Hold one of the lters in place with one
hand and push back on the release
lever with the other.
STEP 2: While pushing back on the release
lever, lower the lter out of the hood.
STEP 3: Repeat steps 1 and 2 for the remaining
lter(s).
STEP 4: Install the new bafe type lters. Insert
the tabs on the end of the lter opposite
the release lever into the slots toward
the back of the hood above the hood
rim. The release lever must be facing
down.
STEP 5: Pull on the release lever while sliding
the free end of the lter into the lter
opening.
STEP 6: Push up on the free end until it stops,
then release the lever. The lter should
lock into place.
Continued on back...
These instructions contain information on the installation and care of the optional bafe style lters for
Dacor EH, EHR and MH series range hoods. The bafe style lters replace that standard mesh type
lters that come standard with the hood.
Bafe Kit
AHBF2, AHBF3, AHBF4
INSTALLATION
INSTRUCTIONS
EH, EHR and MH Series Range Hoods
Part No. 106214 Rev. B
Parts included with this kit
Baffles:
2 for 30 inch and 36 inch wide models (AHBF2)
3 for 42 inch wide models (AHBF3)
4 for 48 inch and 54 inch wide models (AHBF4)
Existing Mesh
Type Filters
Release Lever
Release
Lever
Slots
Dacor ● 600 Anton Blvd. Suite 1000 Costa Mesa, CA 92626 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.Dacor.com
Cleaning the Filters
STEP 1: Remove the lters from the hood to clean them. Hold one lter in place with one hand and
pull on the release lever with the other.
STEP 2: Lower the lter out of the hood.
STEP 3: Follow steps 1 and 2 to remove the remaining lter(s).
STEP 4: Hand wash the lters in hot water with a mild detergent solution or dishwashing soap. You
may also place them in an automatic dishwasher.
STEP 5: Dry the lters completely before reinstalling them according to the installation instructions
on the front page.
/