Akura
ASDVCR141R-S / ASDVCR210R-S
Quick start guide.
Congratulations on purchasing this product. To enable you to enjoy the full
features of this Combined TV, DVD and VCR, you must read the full Customer
User Manual. However to enable you to discover the basic features, please
follow the instructions of this guide.
Connection. Connect the 3 pin UK mains plug into a suitable power wall
socket. Connect a suitable aerial “not supplied” to the aerial socket at the rear.
If you are in a good reception area, a set top aerial may be sufficient, however
normally a larger external aerial will be necessary.
Remote control. Remove the battery cover and fit the two “AAA” batteries
inside the controller, observing the correct polarity of the batteries.
First time operation. Switch the “Mains switch” at the rear of the set to “On”.
A small “Led” indicator adjacent to the “Standby” switch will light red.
Press the “Standby” switch once. The led will go out, and very shortly the TV
screen will light with a noisy, snowy picture.
Tuning the set. Press the “Setup” button on
the handset. A menu will appear. With the
“CH ▼”down button, select “Installation”.
Press the “Enter” button and a new menu will
appear. Using the “CH ▼” button, select “Auto
Installation”. Press “Enter” and the set will
start to search for stations. A “Please wait”
message will be displayed.
Clock set. As soon as “Auto tuning” has been
completed, the set displays, “Clock set”.
Set the “Time” first. Using the 0 – 9 buttons,
Enter the Hours (24 hr) thus if is 6 am, enter
06, if the time is 6 pm enter 18. Set the
minutes in the same way. Set the Date next.
Using the 0 – 9 buttons enter the “Day”, e.g.
21. Next enter the “Month”, e.g.09, (Sept), and
finally the “Year” e.g. 04 (2004). When the
time and date is set correctly, press “Enter”.
Now press “Setup”, and the screen will now
display the first station found.
Moving and Naming stations. When “Auto tuning” has been performed, it is
very unlikely that the stations will be in the correct place. Please refer to pages
19 and 20 of the User Manual to move the stations to the correct locations.
VCR. With the set in TV mode, insert a tape into the VCR slot. To start playback,
press either the ”Play” button on the handset or the “Play” button on the front of
the TV. To record a programme, insert a recordable tape and press the “REC”
button on the handset or the “REC” on the TV. A led will light to state recording is
in progress. For more complex operations please refer to the User Manual.
DVD. To play DVD’s, press the “Function” button on the TV or the
TV+VCR/DVD button on the handset. If no disc is in the player, a floating logo
will be seen on the screen. To insert a DVD disc, press the DVD “Open/Close”
button on the TV or the Eject “Open/Close” button on the handset. Place a
suitable DVD disc facing upwards on the disc tray. Press the Open/Close button
again and the tray will close. The DVD player will search the disc and display
“DVD Loading” on the screen. Some discs will start to play immediately, some
will show a “Menu” from which a selection is made. For more complex functions
please refer to the User Manual.
-
1
-
2
