May 1997
34-7015-5255-5-B
Application
The Scotchlok
™
E-9BM Crimping Tool, with adjustable jaw inserts, crimps Scotchlok
™
discrete type
connectors and is a maintenance tool for modular splicing.
Scotchlok
™
E-9BM Crimping Tool
Selection and Installation of Jaw Inserts
1. Select the jaw insert combination to be used. See Table 1.
2. Remove the jaw inserts from the jaw using a
screwdriver. See Figure 1.
3. Install the jaw inserts in the positions selected by
pushing the tool firmly against a hard surface until they
snap into position.
812031
812032
TABLE 1
Connector Type Jaw Inserts
All Scotchlok Butt and Tap type connectors Thick - Thick
UDW, UIB, UIR and UIY Inline connectors Thick - Thin
All MS
2™
Cross-Connect Modules, all Scotchlok
Inline connectors and all 4000 and 4008 Series Thick-Thin
Modular connectors
Super-Mini 4005 Bridge & 4005DPM Modules Thin - Thin
Figure 1. Removal of jaw inserts
Important Notice
All statements, technical information and recommendations related to the Seller's products are based on information believed to be
reliable, but the accuracy or completeness thereof is not guaranteed. Before utilizing the product, the user should determine the suitability
of the product for its intended use. The user assumes all risks and liability whatsoever in connection with such use.
Any statements or recommendations of the Seller which are not contained in the Seller's current publications shall have no force or effect
unless contained in an agreement signed by an authorized officer of the Seller. The statements contained herein are made in lieu of all
warranties, expressed or implied, including but not limited to the implied warranties of merchantability and fitness for a particular purpose
which warranties are hereby expressly disclaimed.
SELLER SHALL NOT BE LIABLE TO THE USER OR ANY OTHER PERSON UNDER ANY LEGAL THEORY, INCLUDING BUT NOT
LIMITED TO NEGLIGENCE OR STRICT LIABILITY, FOR ANY INJURY OR FOR ANY DIRECT OR CONSEQUENTIAL DAMAGES
SUSTAINED OR INCURRED BY REASON OF THE USE OF ANY OF THE SELLER'S PRODUCTS THAT WERE DEFECTIVE.
Telecom Systems Division
6801 River Place Blvd.
Austin, TX 78726-9000
800/426-8688
Litho in USA
© 3M 1997 34-7015-5255-5-B
Recycled paper
50% pre-consumer
10% post-consumer
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
3M Scotchlok™ Electrical IDC 562-BIN, Yellow, 12 AWG (solid/stranded), 10 AWG (stranded), 1000 /Case Operating instructions
-
-
-
-
-
3M ST MM Plate, 12 Port, Operating instructions
-
-
-
-