Q:\Hyline Offroad, LLC\Installation Instructions\300.600.110 - TJ 50'' LED LIGHT BAR MOUNT\300.600.110 Installation Instructions.doc Page 2 of 2
REV 1 4/14/2016
Light Bar Mount Installation
Step 1 – Using Torx Socket remove the 3 bolts in each windshield pillar (See Figure 1). You will NOT
be re-using this original hardware.
Step 2 – Install both brackets with one rubber liner behind each to protect the vehicle’s painted
surface and fasten using supplied 5/16” x 1” hardware. DO NOT TIGHTEN.
Step 3 – Now install your Light Bar between both brackets. With the mounting bracket hardware
still loose you can run the light wiring behind the brackets. This is only one option for
running wires. It is your decision to run wiring in any other way.
Step 4 – After wiring is run you can tighten the hardware and light bar hardware appropriately.
Send your OFFROAD pictures to pics@HylineOffroad.com . If we choose any one
of your pictures to be used on our website, We send you a FREE Hyline Offroad
T-Shirt.
PLEASE READ INSTRUCTIONS BEFORE BEGINNING INSTALLATION
Installation instructions provided must be read and followed exactly when installing
product. Failure to do so could potentially result in injury or death of any occupants
in the vehicle. WEAR SEAT BELTS AT ALL TIMES WHEN DRIVING!
Though our products are rugged, they are primarily designed and built to enhance the appearance of the
vehicle and will not protect from death or injury in the event of an accident. Adhere to all vehicle
manufacturers specifications