ADDITIONAL SAFETY PRECAUTIONS FOR LIGHTING:
CLEAN UP INSTRUCTIONS FOR ACCIDENTAL BREAKAGE: If the globe breaks, it is not harmful if it is handled properly. KMART
PTY LTD IS NOT RESPONSIBLE FOR DAMAGE CAUSED BY PRODUCT BREAKAGE.:
1. Contains non-replaceable LED bulbs
2. Place the item on a flat, dry, and sturdy surface.
3. Handle product with care; globe may break if subjected to any form of sudden impact.
4. Do not remove the cap on the globe or add anything to the globe. The air space at the top of the globe is necessary in order to allow
for the expansion of contents. Breaking the seal on the globe shall void the warranty.
5. To clean product, use a dry cloth. DO NOT submerge in water.
6. DO NOT operate on hot surfaces.
7. This product is intended for personal indoor household use only – DO NOT use outdoors.
8. Keep product out of reach of small children and pets. This item is NOT a toy.
43316731 Rainbow Glitter Lamp
SLR-23003
IMPORTANT SAFETY INSTRUCTIONS:
The following safety precautions should always be followed, to reduce the risk of electric shock, personal injury or fire. It is
important to read all of these instructions carefully before using the product, and to save them for future reference or new
users.
1. This product must only be used as intended in accordance with the enclosed operating instructions.
2. Do not carry the appliance by the cable or pull the cable to remove the plug from the socket.
3. If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manufacturer or his service
agent or a similar qualified person in order to avoid a hazard.
4. If the appliance stops unexpectedly or appears to malfunction, switch off the power supply, unplug from the mains and stop using
immediately. Seek professional advice to rectify the fault or make repairs.
5. Switch off the power supply and unplug from the mains socket when not in use, before cleaning or changing accessories.
6. Avoid positioning the appliance where the power cable might be accidentally trapped or damaged.
7. Keep the appliance and cable away from sources of heat, sharp objects or anything that may cause damage.
8. Ensure the appliance is switched OFF before connecting the mains power supply.
9. This product has not been designed for use by children.
10. Children should be closely supervised at all times when they are near any electrical appliance.
11. Never reach for any appliance that has fallen into water. Switch off the power supply at the mains immediately and unplug. Do
not re-use until the product has been inspected and approved by a qualified electrician.
12. Always ensure that hands are dry before operating or adjusting any switch on the product or touching the plug and mains supply
connections.
13. Where relevant keep all ventilation slots, filters, etc. uncovered and clear of debris. Never drop or insert objects into the openings.
14. Do not use outdoors. This appliance has been designed for domestic indoor use only.
1. Wear rubber gloves during the clean-up process in order to protect skin irritation and to prevent cuts from broken plastic.
2. Carefully pick up and dispose of broken plastic pieces.
3. Use disposable towels to soak up excess liquid (you can use water to aid in clean up because the liquid is water soluble).
4. Thoroughly clean any products soiled by the liquid.
5. After the liquid has been cleaned up, a commercial cleaning detergent may be used to deep clean the area. Prompt clean-up is key.
6. For carpet, blot up spilled material with an absorbent disposable cloth. Follow cleaning directions from your carpet manufacturer.
7. For floors, wipe up with disposable cloth and clean with normal floor cleaning detergent.
First Aid:
1. For ingestion: Seek medical attention.
2. For direct contact to eyes: Flush open eye with a direct stream of water for 15 minutes and then seek medical attention.
3. For direct skin contact: Clean the affected area thoroughly with soap and water. Remove and wash contaminated clothing immediately. If irritation
occurs, then seek medical attention.
Rated voltage: 5V DC 500mA
Product specification
This lamp contains non-replaceable LED bulbs
INSTRUCTIONS FOR INSTALLATION:
Remove all excess packaging before installation.
Insert USB into a suitable USB outlet (e.g. LAPTOP computer, USB socket or USB mains adapter).
Switch on using the in-line switch.
1.
2.
3.