CoverCraft UV11553 Installation guide

  • Hello! I've reviewed the installation instructions for the Covercraft UVS100 Custom Sunscreen. This document provides step-by-step guidance on how to install the sunscreen in your vehicle, including how to avoid damaging the product. I'm ready to answer any questions you might have about the installation process or the product's features.
  • Does the UVS100 Custom Sunscreen cover the entire glass area?
    How do I install the UVS100 Custom Sunscreen?
    How do I store the UVS100 Custom Sunscreen?
Form # 6317507 (05/14)
Installaon Instrucons
For more instrucons and “How To” videos, visit Covercras
YouTube Channel: www.youtube.com/covercra1965
IMPORTANT NOTICE
UVS100® Custom Sunscreens do not cover the enre glass
area on some vehicles. Windshield pillar post size and an-
gle, rearview mirror shape and size, and addional sensors
can prevent some Sunscreens from providing total blackout
coverage.
STEP 1
Unfold your UVS100® Custom Sunscreen with the reecve side
facing outward and place it as at as possible onto the dash area.
If there are assist handles on the windshield pillars, make sure
the Sunscreen ts in front of them. Then slide it forward unl
it reaches the boom of the windshield ahead of the defroster
vents.
STEP 2
With both hands, li the top of the UVS100® Custom Sunscreen
into the windshield area.
NOTE: Be careful to not bend the corners while installing, as
damage to the inner insulator may occur.
STEP 3
Pull down each sun visor to hold the UVS100® Custom Sunscreen
in place. In some cases, the Sunscreen may not reach all the way
to the windshield pillars. This addional space is necessary to be
able to install the Sunscreen without damaging it.
REMOVAL
Simply reverse the installaon steps, fold the unit and store in
the trunk or under a seat.
www.covercra.com
(Oponal storage bag shown)
/