Setup
1. Screw the Target Hook by hand into the center hole on the target board.
Make sure Target Hook end does not protrude from back of the Target
Board. (Must be flush as to not damage wall). Also, ensure Target Hook is
in upright position as per the above diagram.
2. Mount the Target Board on wall, approximately 4 to 5 feet high using the
adhesive tape and or screws enclosed.
3. Screw Eye Hook into ceiling in line with and approximately 4 to 5 feet
away from the wall that the Target Board is attached to.
4. Tie string to the Ring and place Ring onto the Target Hook.
5. With help, hold the Ring in the horizontal position on the Target Hook and
tie the open end of the string onto the Eye Hook. Note, there must be a
slight amount of slack in the string which will allow the Ring to hook onto
the Target Hook when properly tossed. Adjust slack in string to achieve
the optimum playability of the Hook & Ring game.
Note: This Hook & Ring Set can be attached and played on trees, decks,
etc., depending on the correct location of the tree limbs and deck ceilings
for installation of the Eye Hook. Simple fixtures can also be made from 2x4
lumber to accommodate both the Target Board and Eye Hook.
