Page is loading ...
Page 1 / 2
Produced for:
© dekoVries GmbH · Schultze-Fimmen-Str. 2 · 26689 Apen · Germany · www.deVries-Group.de
ASSEMBLY INSTRUCTIONS RETURN SPRING
Subsequent installation
1
3
5
2
4
6
Material
Loosen the side panels Step 2:
Carefully unscrew the carrying handle
Slowly tilt the upper basket all the way back
(ATTENTION, please carry out the work step with two people!)
Loosen the side panels Step 1:
Carefully unscrew the adjustment handle
Loosen the side panels Step 3:
Carefully unscrew all the remaining screws on the side panel
Insert the defl ection roller in the recess recess (all the way to
the front), pre-drill holes (3 mm) and then screw tight
ATTENTION:
Since a return spring
is mounted on both
sides, the work steps
must also be carried
out once on
both sides!
Recess
Recess
Recess
ASSEMBLY INSTRUCTIONS RETURN SPRING
Subsequent installation
Page 2 / 2
Produced for:
© dekoVries GmbH · Schultze-Fimmen-Str. 2 · 26689 Apen · Germany · www.deVries-Group.de
7
9
11
8
10
12
Place the bracket on the upper basket (hook down), pre-drill
holes (3 mm) and then screw tight
Screw the spring tight
Thread the wire rope through the pulley and hook it into the
hook on the upper basket (ATTENTION: thread the rope in at
the front)
Put the screw through the hole in the lower basket
(ATTENTION: tilt the beach chair slightly with 2 people to do this)
ATTENTION: Pay attention to the orientation of the eyelet!
Carefully bend the hooks on the upper basket together with
pliers. Reassemble the side parts, handles and adjustment
handles.
/
