8PCS 5/16" Washer 8PCS 5/16" Spring Washer
8PCS 1/4"x1-3/4" Machine Bolts21
3
Hardware ListHardware List
DESK TOP BA 1 PC 2 PCS
LEFT LEGS
Parts List
Assembly is complete.
(A)
(B)
Caution: Please read instructions thoroughly before unpacking assembly parts. Sharp, exposed staple tips can cause injury,
therefore, for your protection, please remove any exposed staples used in packing.
Please keep all hardware parts out of the reach of children.
1.We recommend that you should assemble this product with the assistance of another person; this will make assembly easier,
and will help to eliminate damage to the product or injury to persons during assembly.
2.Be sure to check all packing materials carefully for small parts that may have come loose inside the carton during shipment.
3.Please do not over tighten screws or bolts.
Reminder
1.Use only the hardware supplied.
2.Do not over-tighten the bolts.
3.This item may require periodic tightening.
4.Phillips screwdriver not included.
Step 1. Turn the Desk Top (A) upside down on a protective surface such as carpet or other soft material.
Insert one Stretcher (D) into the pre-drilled holes on Legs (B) and (C), make sure that the screw holes on
the Stretcher are facing up.
Step 2. Mount Legs (B) and (C) on the corner blocks from the desk top and secure using Flat Washer (1),
Spring Washer (2), Machine Bolt (3) as shown in Fig. 1 . Secure Stretcher (D) to Legs (B) and (C) using
Flat Head Wood Screws as shown in Fig. 2.
Step 3. Repeat Steps 1 and 2 for the rest of the legs and stretcher.
Step 4. Turn the fully assembled desk table to upright position.
Fig.1.
DSTRETCHER
X4 4
(D)
44PCS 1" Flat Head Wood Screws
up
down
adjust leveler
from here.
CRIGHT LEGS
(B)
(C) (C)
Fig.2.
2 PCS 2 PCS
/
![HomeSullivan405302C-36(3A)[5PC]-24](http://vs1.manuzoid.com/store/data/000635708_2-6da331492e1541846a6c99271607eafe-160x210.png)
