Classic Accessories 70-007-013701-00 Owner's manual

Installation

Your Heritage Cargo Protector attaches to

the tops of the rear seats with adjustable

straps.

The straps can be fitted on a variety of seats

or hardware.

1. Attach the Cargo Protector to the rear seat:

Simply loop the two webbing straps around

the headrests and clip the side release buckles

together.

2. Adjust the strap length as needed for your

vehicle.

3. Lay Cargo Protector flat over cargo area.

Cleaning

Machine wash in COLD water. DO NOT USE SOAP

as it may remove the protective coatings added

by the factory. Line dry or machine dry on air or

delicate.

Instructions: Heritage Cargo Protector

On back seats with headrests loop straps around the

headrest posts

On back seats without headrests attach straps to seat

backs, latches, hand rests or spare tire holders

09cP53_1079970-007-013701-00

Ready to go in 5 easy steps

1. Fold the top down

to where the zipper

is on the fold.

2. Fold one side to

where the zipper

is on the fold.

3. Fold the other

side to where

the zipper is on

the fold.

4. Fold the Cargo Protector

together to where both

handles are together.

5. Zip together.