ELECTRONIC CONTROL PANEL
A. Indicator LEDs to display the current temperature
setpoint or the Fast Cool function
B. Pushbutton for Temperature setting (short pressure) or
Fast Cool activation (long pressure – 3 sec.)
TEMPERATURE SETTING
Press the Temperature button (B) on the control panel to
adjust the temperature from the warmest through the lower
to the coldest level.
Pressing the Temperature button, the temperature setting
will change cyclically.
The temperature setting works for both the refrigerator and
the freezer compartments at the same time. At first plug-in
of appliance temperature setpoint is present at medium
position (factory setting).
Following table shows temperature setpoints:
Legend: Led ON Led OFF
FUNCTIONS
Fast Cool
The use of the Fast Cool function is recommended:
- to increase the cooling speed of the refrigerator
compartment when placing a very high quantity of food
within it,
- to maximize the freezing capacity of the freezer
compartment: for this reason you should activate the
Fast Cool function before placing fresh food to be
frozen in the freezer compartment.
To activate the Fast Cool function, press and hold for 3
seconds the pushbutton on the control panel: all the 3
LEDs on the control panel will turn on.
The function is automatically deactivated after 24 hours.
The function can be manually deactivated by pressing
and holding the same pushbutton on the control panel
for 3 seconds.
/ "6th Sense" / "Green Intelligence"
The "6th Sense "/ "Green Intelligence" function is
automatically activated when:
• a large amount of food is loaded into the refrigerator
and/or freezer
• the refrigerator and/or freezer door is left open for a
long time
• a prolonged power failure takes place, causing the
internal temperature of the appliance to increase to
values that cannot guarantee safe storage of food.
ECO GREEN (depending on the model)
This function gives best food preservation performance
with the smallest energy consumption possible if there is
a lower amount of food to be preserved in the appliance.
When ECO GREEN function is activated only these
compartments should be used in order to have the best
food preservation:
- 2 "eco green" areas in the fridge ( indicated by green
stickers)
- 1 "eco green" basket for storing frozen food (item 15a)
in freezer compartment.
To active the Eco Green function press the pushbutton
on the control panel to choose the mid-high
temperature, as showed here below:
FREEZING FRESH FOOD
Before placing fresh food to be frozen in the freezer
compartment you should activate the Fast Cool function.
Place the fresh food to be frozen on the freezer shelves in
freezer compartment.
Avoid direct contact with already frozen food.
Place the fresh food just after activation of Fast Cool. After
24h from activation, function will turn off automatically.
ABNORMAL APPLIANCE OPERATION
When any failure appears, any LEDs start blinking, it is
necessary to call service.
The appliance will work preserving the food stored.
Note: In case of power failure, appliance goes back to
normal operation and previously chosen temperature
setpoint is restored.
CLEANING
Important: Before carrying out any cleaning or maintenance
operation, unplug the appliance or disconnect it from the
high temp.
med-high temp.
medium temp.
med-low temp.
low temp.
CA
UKR
ROBG
RUS
HSKCZPLFINDKNSGRIPENLFGBD
PRODUCT SHEET
GB