VENTILATORE A TORRE
TOWER FAN
TURMVENTILATOR
VENTILATEUR À COLONNE
VENTILADOR DE TORRE
TITANO – TITANO B
RoHS
MANUALE D'ISTRUZIONI - INSTRUCTION MANUAL
BEDIENUNGSANLEITUNG - LIVRET D'INSTRUCTIONS
MANUAL DE INSTRUCCIONES
OI 12
Page is loading ...
Page is loading ...
1.Remote & Control panel
2.LED function Indicator
3.Temperature Display
4.Main body
5.Air Outlet
6.Speed indicator display
7.Base
8.Screws for base (Ø 4mm x 4)
9.Adaptor
10.DC Jack A
11.DC Jack B
12.Detachable Rear Guards
Fig.A Fig.B
APPLIANCE COMPONENTS
1.Assemble the front base and the rear base.(Fig.A)
2.Insert the main body into the base using the screws supplied .(Fig.B)
3.Inset DC Jack A cord to the base .(Fig.C)
4.Connect the DC Jack B cord to the DC Jack A cord.(Fig.D)
10
6
1
8
11
Fig.C
Fig.D
Fig.C
GENERAL DIRECTIONS
1. Remove the packaging and make sure that the appliance is intact. If in doubt, do not use it and
contact our Technical Assistance Centre. Packaging materials (plastic bags, polystyrene, staples
etc.) must be kept out of the reach of children as they could be hazardous.
Caution:
- This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their
safety.
- Children should be supervised to ensure that they do not play with the appliance.
2. Before connecting the appliance, check that the appliance rating corresponds to the mains
rating.
If the power cord is damaged, it must be replaced by the manufacturer or its service agent or a
similar qualified person in order to avoid a hazard.
3. This appliance must only be used for the purpose for which it has been manufactured, i.e. as a
tower fan. The manufacturer is not responsible for any damage caused by improper or incorrect
use.
4. Before cleaning or carrying out maintenance on the appliance, disconnect it from the electrical
mains by pulling out the main plug.
5. If the appliance is faulty or operating incorrectly, switch it off without tampering with it. If the
above is disregarded, the safety of the appliance may be compromised.
6. Turn off the appliance and remove the plug from the electrical outlet when the appliance is not
in use.
7. The use of any electrical appliance calls for the awareness of some basic rules, such as:
- do not use the appliance near sources of water such as baths, showers or swimming pools
- do not touch the appliance with wet or damp hands or feet
- do not leave the appliance exposed to atmospheric agents
8. Max. ambient temperature 40°C.9. Do not use the appliance in the presence of potentially
flammable or explosive liquids or gases.
10. The appliance conforms with Directives 2004/108/EC regarding Electromagnetic Compatibility
(EMC) and Directives 2006/95/EC regarding Low Voltage (LV).
11. This product is intended for household use ONLY and not for commercial / industrial or
outdoor use.
ENGLISH
ASSEMBLY
05
06
Remote control was in the top of the fan
body. press the logo side of the remote
control (see Fig.E) to release it from
remote control holder
Fig.E Fig.F
Before starting to use the remote control,
remove the plastic protection from the battery.
Replacing the battery (CR2025)
3
2
4
5
7
12
9
MAINTENANCE & CLEANING
Before carrying out routine cleaning, switch off the fan and disconnect mains power. Use a soft,
damp cloth only and do not use abrasive substances.
NB:. Do not submerge any part of the fan in the water.
Attention: To avoid injured, dangerous and damage, please remember to disconnect the plug
before cleaning and remount the rear guards after cleaning and before use.
TECHNICAL DATA
Power supply: 12 V DC
Power: 30 W
Dimensions: 1200 x 300 x 300 mm
Weight: 3.7 kg
CAUTION
The symbol on the product means that at the end of its life, the appliance must not be
considered normal waste but hazardous waste and, as such, must be disposed of in specific
recovery and disposal areas, as prescribed by the EC Directive 2002/96/EC (WEEE). By
disposing of this product correctly, you can prevent negative consequences for the environment
and for human health, due to the presence of potentially hazardous substances in the product.
For more detailed information about recycling this product, contact the local authorities, the local
waste disposal service or the shop from which the product was purchased. Unlawful disposal will
be punished according to the law.
Fan ON/OFF button
Speed selection button: 1 / 2 / 3 / 4 / 5
Oscillation ON/OFF button
Selectable air delivery & Natural Mode button
Timer Setting button: 2 / 4 / 8 hours.
Insert the plug into a power outlet.
ON/OFF button
related LED function indicator light goes on.
to switch on or switch off the fan. When the fan switches on, the
5 levels speed control, press this key to change the speed,
function indicator light goes on, speed level shows in the bottom of the unit
the related LED
Oscillating function, press it will allow the Fan to
stop oscillation
oscillate, press once more to
Selectable air delivery position (top panel related LED function indicator light
goes on.),
st nd st nd
- press once: 1 +2 fans open (1 and 2 Speed indicator goes on);
nd rd nd rd
- press twice: 2 + 3 fans open (2 and 3 Speed indicator goes on);
rd th rd th
- press third: 3 + 4 fans open (3 and 4 Speed indicator goes on);
press fourth to select the Natural Mode. Natural Mode: 4 fans open, speed will
change in each 10 seconds, sequence as: speed level 1,2,3,4,5,4,3,2,1 (move in
circles, related Speed indicator goes on).
st nd
Press this key again returns to 1 + 2 fans open.
Press the TIMER key to set 2 / 4 / 8 hours timer setting,
indicator light goes on: Red: 2 hours; Orange: 4 hours; Green: 8 hours. when the
time is over, the fan will switch off automatically (returns stand by mode).
the related LED function
OPERATION
07
08
If the fan is really dirty, you can detach rear guards
and clean inside of the fan.
1． screws of the rear guards by a sized screw
driver;
2．turn the rear guards counterclockwise and take
it out;
3．use vacuum cleaner to clean the dust or use a
damp cloth to remove the dust on fan, but fan is
not detachable from motor shaft and do not uses
water to clean it;
4． after cleaning, close the rear guards by turn it
clockwise and screwed before use.
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/
