42
Drink preparation with milk
The appliance must be ready for use.
Place the suction pipe 10d of the milk
frother 10 deep in the milk container 26.
Swivel the coffee outlet 9 to the right until
it clicks into place.
Place the pre-warmed cup or glass under
the coffee outlet 9 and milk frother 10.
Select the required Caffe Latte,
Macchiato, Cappuccino or My coffee by
turning the rotary knob 6.
Open the powder compartment 18.
Pour in no more than 2 level measuring
spoons 14 of ground coffee.
¡ Warning!
Do not use whole beans or instant coffee.
Close the powder compartment 18.
Press the start button 8.
First milk is delivered into the cup or glass.
Then the coffee is brewed and dispensed
into the cup or glass.
Important:
to remove, so the milk frother 10 must be
cleaned with lukewarm water immediately
after use (see “Cleaning the milk system”).
Note:
cup of coffee / milk drink. If coffee is not
dispensed within 90 seconds, the brewing
chamber empties automatically to avoid an
Preparing milk froth and
warm milk
¡ Risk of burns!
The milk frother 10 gets very hot. After use,
The appliance must be ready for use.
Place the suction pipe 10d of the milk
frother 10 deep in the milk container 26.
Place the pre-warmed cup or glass under
the outlet of the milk frother 10.
Select the required setting
Milk froth or
Warm milk by turning the rotary knob 6.
Press the start button 8.
of the milk frother 10.
Press the start button 8 again to cut the
process short.
Info: When preparing warm milk, you may
hear a whistling sound. This is caused by
the milk frother for technical reasons.
Tip: For optimal milk froth quality, use cold
milk with a fat content of at least 1.5 % if
possible.
Important:
to remove, so the milk frother must be
cleaned with lukewarm water immediately
after use (see “Cleaning the milk system”).
TE809_1DE.indb 42 08.05.2013 12:10:14