Air Hogs AH Robo Copter Recon Quick start guide

Contents:

1 AH Robo Copter Recon™

1 Controller/Charger

1 Instruction Sheet

AH Robo Copter Recon™

Controller/Charger

Congratulations on your purchase of the AH Robo Copter Recon™. Your AH Robo Copter Recon™ comes

complete and ready to fly (requires 4 1.5 V AA alkaline batteries [not included]) so you can start to fly as soon as

you have thoroughly read the instruction manual and have charged the built-in flight battery.

• Advanced infrared radio control system with digital trims

• Proportional throttle and steering control (2 channels)

• Computer designed figure

• Durable foam body

• Built-in LiPo battery for longer flight duration

• Can be recharged using the charge cable inside

the controller/charger

Key Features:

Main parts:

How to charge:

Open Cover

Install 4 1.5 V AA Alkaline Batteries

(not included) (Check polarity)

Close Cover

Controller/Charger battery installation:

Charge flight battery with your controller/charger:

Main rotor

Stabilizer

Connecting shaft

Tail rotor

Charging port

Landing gear

Throttle trim

Steering trim

Steering

Throttle

Power indicator

Power switch

IMPORTANT: Make sure the controller/charger and

Robo Copter Recon™ have their power turned ‘OFF’

before charging.

Troubleshooting:

Problem

1. Unit does not operate.

1. Robo Copter Recon™ won't lift.

1. Loss of control.

Possible Cause

1. Controller/charger AA batteries are depleted or

installed incorrectly as indicated by the low-battery alarm.

2. Robo Copter Recon™ battery is not charged.

3. Crash has damaged the Robo Copter Recon™.

4. Robo Copter Recon™ is not turned on.

1. Running out of flight battery.

1. Running out of controller/charger battery.

Solution

1. Check polarity installation or

replace with fresh AA batteries.

2. Fully charge the battery.

3. Replace the Robo Copter Recon™.

4. Turn on the Robo Copter Recon™.

1. Recharge battery.

1. Replace controller/charger battery.

Controller Battery Information:

• Battery installation should be performed by an adult.

• Be careful to install batteries with correct polarity as indicated.

• Do not mix new and old batteries.

• Do not mix alkaline, standard, rechargeable or different types of batteries.

• Different types of batteries or new and used batteries are not to be mixed.

• Exhausted batteries are not to be removed from the toy.

• Non-rechargeable batteries are not to be recharged.

• Rechargeable batteries are only to be charged under adult supervision

(if removable).

• Rechargeable batteries are to be removed from the toy before being

charged (if removable).

• Only batteries of the same or equivalent type as recommended are

to be used.

• The supply terminals are not to be short-circuited.

• Do not dispose of batteries in fire. Battery may explode or leak.

Important Battery Information:

FCC REQUIREMENTS

• Charging operation should be performed by adults only.

• Always fully charge the battery in repeat use.

• The supply terminals are not to be short-circuited.

• Do not use the battery with the positive and negative terminals reversed.

• Do not attempt to open, disassemble or short-circuit the

Robo Copter Recon™.

• Stop using and do not recharge the Robo Copter Recon™ that shows

leakage, damage or deformation.

• Do not allow the battery to get wet.

• Always store the Robo Copter Recon™ in a cool and dry place.

• Dispose Robo Copter Recon™ properly and never dispose of battery

pack in fire.

• Do not recharge the Robo Copter Recon™ immediately after use. Wait

until it is cool before charging.

• Do not charge near fire, where temperature is extremely high (flammable

item), or where it is wet or damp.

• Do not leave the battery in direct sunlight.

• DO NOT continue to charge the battery if the charger fails to recognize

full charge. Overheating or swelling of the battery cells is an indicator that

they are in an overcharged condition, and the batteries should be

disconnected from the charger immediately!

• DO NOT allow battery to overheat at any time! Cells which reach greater

than 140°F (60°C) can and USUALLY WILL become damaged physically

and could possibly catch FIRE! Always inspect a battery which has

previously overheated for potential damaged, and do not re-use if you

suspect it has been damaged in any way.

• DO NOT allow batteries to be charged or discharged on or near

combustible materials, including paper, plastic, carpets, vinyl, leather,

wood, inside an R/C model or full-sized automobile!

• ALWAYS provide adequate ventilation around batteries during charge,

discharge, while in use and during storage. If a battery becomes

overheated, remove it from the charger IMMEDIATELY and place it in a

fire-proof location until it cools.

• DO NOT modify the battery in any way which might result in permanent

damage or dangerous responses.

WARNING:

Lithium Polymer (LiPo) batteries are very different from other types of batteries and must be handled and disposed of properly. Please refer to and read the

included care and handling instructions for this part.

This device complies with FCC part 95 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful

interference. 2) This device must accept any interference received, including interference that may cause undesired operation. WARNING: Changes or

modifications not expressly approved by the party responsible for its compliance could void the user’s authority to operate the equipment.

Spin Master Ltd., 450 Front Street West, Toronto, ON

M5V 1B6 Canada

Spin Master Inc., PMB #10053, 300 International Drive,

Suite 100, Williamsville, NY 14221, USA

Spin Master Toys Far East Limited. Rm #1113, 11/F,

Chinachem Golden Plaza, 77 Mody Rd., Tsimshatsui E.,

Kowloon, HK

North American Consumer Information

Phone: 1-800-622-8339

www.spinmaster.com

registered trademark of Spin Master Ltd. Robo Copter

Recon TM is a trademark of Spin Master Ltd. All rights

reserved. Manufactured for and distributed by Spin Master

Ltd. Conforms to product safety standards ASTM F963-03,

EN71 regulatory requirements. Products and colors may

vary. Please retain this information for future reference.

Patent Pending. MADE IN CHINA.

#20009979, #20009980 NEN REV 0

Contains LiPo battery pack.

Battery pack must be

recycled or disposed of

properly.

WARNING: Any change or modification to this product without written approval by the party responsible for compliance

is prohibited.

• Choking hazard: Includes small parts, not for children under age 10.

• Keep everything, especially hair, away from the main rotors and tail rotor when Robo Copter Recon™’s power is on.

• Make sure the controller/charger and Robo Copter Recon™ have their power turned ‘OFF’ when not in use.

• Keep your Robo Copter Recon™ in sight at all times when flying.

• Do not attempt to charge any battery other than the specified built-in one with the charger in the controller/charger.

• To help to protect your Robo Copter Recon™ from damage, remember to close the throttle (pull the throttle stick down)

immediately to stop the rotors if your Robo Copter Recon™ falls over or hits something.

Do not touch the PCB (receiver) on your Robo Copter Recon™ with anything, especially metal, to avoid

any unnecessary damage. This is not a consumer serviceable item.

Notes for Adults:

• Examine the Robo Copter Recon™ carefully for any possible damage prior to every flight. Do not attempt to fly until all

damage has been repaired.

• Adult supervision is required when a child is charging the battery in the Robo Copter Recon™ or installing/replacing the

batteries in the controller/charger.

Notes for Maintenance:

• Remove the batteries installed in the controller/charger if you are not going to use this product for a long time.

• Clean the controller/charger’s surface with a dry soft cloth if it is dirty. Do not use any water or spray cleaner on the

controller/charger.

• Store this product in a cool dry place.

• Replace the batteries in the controller/charger when you hear the low battery alarm (beeping sound). If you do not replace

the batteries in time, you could lose control of your Robo Copter Recon™ or crash it.

Safety Precautions:

Caution:

Special Caution:

Making Flight Adjustments (Robo Copter Recon™ turns left or right):

Making Flight Adjustments (Robo Copter Recon™ turns left or right): The steering trim makes small adjustments to

Robo Copter’s direction. If the nose (front) turns right press the opposite trim to the direction Robo Copter Recon™

is turning. Turns right-Trim left. Turns left-Trim right.

Flight control:

For smooth control of Robo Copter Recon™ always make small control movements.

• Flying up and down: When your Robo Copter Recon™ is stable in the air, gently push/pull the stick up/down

to make it ﬂy higher/lower.

• Turning left and right: After you are proﬁcient in controlling the ﬂying height of your Robo Copter Recon™, try turning

left/right by moving the steering stick to the same direction.

• The Robo Copter Recon™ has a balance weight on the carbon

boom to adjust the ﬂight speed. The recommended position

at the rear is for slowest forward speed. As you become more

experienced slide the adjuster progressively towards the

front to increase the forward ﬂight speed.

Flight Tips:

• The Robo Copter Recon™ will slightly speed up/gain height turning right and slow down/loose height when turning left.

• For ground take off, put the Robo Copter Recon™ on the smooth ground and quickly push the throttle stick up to lift off.

Flying from rough ground may result in a clumsy take off or even cause the Robo Copter Recon™ to fall over.

• Do not look at the controller/charger when ﬂying focus completely on the Robo Copter Recon™.

• Indoor ﬂight only is recommended. It is easier and smoother if there is no wind from air conditioning or open windows.

• Please allow enough space for the ﬂight (13 x 16 x 10 feet is recommended).

• After each ﬂight, rest the ﬂight battery for 1 minute prior to recharging in order to extend the battery life. This time will

allow the battery to cool down before recharging.

Warnings and Safety:

• Never ﬂy near people, pets or furniture.

• When ﬂying the Robo Copter Recon™, ensure you are a safe distance from people.

• Adult supervision is recommended for ages 10 and under.

• Keep the main rotors away from clothing or body parts, even when not rotating, as they could be turned on by accident.

Turns left

Trim right

Turns right Trim left

Charging your Robo Copter Recon™:

The Robo Copter Recon™’s charger has unique peak detection circuitry that ensures an accurate charge every time and

protects your battery from the dangers of overcharging. During the charge cycle it continually monitors the battery’s charge

curve and automatically stops charging when the peak/full charge is detected.

1. Make sure the controller/charger and Robo Copter Recon™ power switches are turned ‘OFF’.

2. Attach the controller/charger’s charge lead (in the bottom of the controller/charger) into the charging port on the

Robo Copter Recon™.

3. The LED indicator on the controller/charger will be solid when the battery is being charged, and then the LED will ﬂash

when battery is close to full. The LED will go out when battery is fully charged.

Lifting off for the first flight:

1. Pull the throttle stick down to the bottom of its travel and then turn ‘ON’ the controller/charger.

2. Keeping everything clear from the rotors turn ‘ON’ the Robo Copter Recon™ power switch.

3. Place the Robo Copter Recon™ on the ground with the tail pointing towards you.

4. Gently push the throttle stick up, the main rotor will spin up and Robo Copter Recon™ will take off. Climb to 3–5 feet

high and hold that height.

5. If you notice that your Robo Copter Recon™ wants to ‘wander/turn’ to the left or right, some adjustments may be necessary.

6. If the Robo Copter Recon™ appears to tip over or skid on the ground, advance the throttle faster.

WARNING:

Before You Fly!

The Robo Copter Recon™ is not a simple toy; it is a sophisticated micro ﬂyer that

needs to be cared for properly.

For your ﬁrst ﬂight, practice in the largest room available and launch from your hand

as shown. The legs and stabilizers of Robo Copter Recon™ are fragile, always pick

up the Robo Copter Recon™ as shown.

Take care when ﬂying and landing Robo Copter Recon™.

Problems?

DO NOT RETURN TO THE RETAILER, CONTACT OUR

CUSTOMER CARE DEPARTMENT

1 800 622 8339 OR VISIT WWW.AIRHOGS.COM

Insert plug

correctly.