Bestron DT48C User manual

SUMMER BREEZE

DE

Handleiding

Bedienungsanleitung

Mode d’emploi

FR

NL

EN

Manual del usuario

Instruction manual

Istruzioni per l’uso

IT

ES

50

Hz

220

240

Volts

DT48C

INSTRUCTION MANUAL

60

Watts

T

O

P

Q

U

A

L

I

T

Y

G

U

A

R

A

N

T

E

Page is loading ...

CONGRATULATIONS!

Congratulations with the purchase of this Bestron product. These

instructions tell you how the product works and how to use it. Read the

instructions carefully before you start using the appliance. Only use

the appliance in the manner described in the instructions. Keep these

instructions in a safe place for future reference.

Defects:

If the appliance is defective, do not try to repair it yourself. Always have

a qualified mechanic carry out any repairs.

Children:

• This appliance may be used by children over the age of 8 years old

and persons with reduced physical, sensory or mental capabilities

or lack of experience and know-how, but only if supervised or if

they have been instructed on how to use the appliance safely and

are aware of its potential dangers.

• Children are not allowed to clean and maintain the appliance,

except if they are over the age of 8 years old and supervised.

• Keep the appliance and the cable out of reach of children under the

age of 8 years old.

• Keep an eye on children to ensure that they do not play with the

appliance.

WHAT YOU SHOULD KNOW ABOUT ELECTRICAL

APPLIANCES

• Check that the mains voltage corresponds with that shown on the

rating plate of an electrical appliance before you use it.

• Check that the socket to which you connect the electrical appliance

is earthed.

• Always install electrical appliances on a stable and level surface

where it cannot fall over.

• Certain parts of an electrical appliance may become warm or

sometimes hot. Do not touch them as you may burn yourself.

• Make sure your hands are dry when you touch an electrical

appliance, a cord or a plug.

• Electrical appliances must be able to lose their heat to avoid fire

hazards. Therefore, make sure that the appliance has sufficient

clearance around it and that it does not come into contact with

flammable materials. Electrical appliances must never be covered.

• Make sure that electrical appliances, cords or plugs do not come

into contact with water.

29

EN

Never immerse electrical appliances, cords or plugs in water or any

other liquid.

• Do not touch electrical appliances if they have fallen in the

water. Immediately pull the plug out of the socket. Stop using the

appliance.

• Make sure that electrical appliances, cords and plugs do not come

into contact with heat sources, such as a hot hob or open fire.

• Never let cords hang over the edge of the sink, a worktop or a

table.

• Always remove plug from the socket when you are not using the

electrical appliance.

• Remove the plug from the socket by pulling the plug itself and not

the cord.

• Regularly check if the cord of the electrical appliance is not

damaged. Do not use the electrical appliance if the cord shows

signs of damage. If the cord is damaged, it should be replaced by

the manufacturer, a technical service provider or a person with an

equivalent qualification, to avoid any danger.

• The appliance may not be switched on with the aid of an external

time switch, or by a separate system with remote control.

WHAT YOU SHOULD KNOW ABOUT THIS APPLIANCE

• Be careful when using the appliance outdoors.

• Never use the appliance in damp or wet locations.

• Thoroughly clean the appliance after use (see Cleaning and

Maintenance).

• We recommend the installation be performed by a qualified electrician

who can check the strength of the supportive ceiling members and

make proper electrical connection.

• To reduce the risk of personal injury, use only the two steel screws

(and lock washer) provided for mounting.

• To reduce the risk of personal injury, do not bend the blade holders

when installing the holders, balancing the blades or cleaning the fan.

30

EN

ENVIRONMENT

• Dispose of packaging material such as plastic and cardboard

boxes in the designated containers.

• Do not dispose of this product as normal domestic waste

at the end of its life, but hand it in at a collection point for

the reuse of electric and electronic equipment. Look for the

symbol on the product, the user instructions or the packaging

showing the type of waste.

• The materials can be used as indicated. By helping us

reuse and process the materials or otherwise recycle the

old equipment, you will be making an important contribution

towards the protection of the environment.

• Your municipality can tell you where to find the designated

waste collection point in your neighbourhood.

CE DECLARATION OF CONFORMITY

This product meets the requirements of European guidelines.

R. Neyman

Quality control

31

EN

OPERATION - General

The appliance is intended only for

domestic use, not for professional use.

1. Mounting Plate

2. Canopy

3. Down rod

4. Motor

5. Fan blades (3x)

6. Screws (2x)

MONTAGE - Installing the mouting plate

WARNING:

• ALWAYS SWITCH OFF THE MAINS POWER BEFORE INSTALLING OR CARYING OUT ANY WORK

ON THE CEILING FAN.

• Be sure to hang the fan in a place where the distance between the fan blades and the floor will be at

least 2.30m.

1. In the packaging the mounting plate is already assembled to the canopy by four screws (see figure A).

2. Loosen the two screws

1

halfway (B).

3. Unscrew the two screws

2

completely and remove them (C).

4. Remove the mounting plate from the canopy and unscrew the yellow-green earth wire from the canopy (D).

5. Lead the wires emerging from your ceiling through the opening in the mounting plate (E).

6. Screw the mounting plate to the ceiling (F). Make sure the mounting plate is mounted firmly enough to

hold a minimum weight of 23 kg (51 lb).

1

2

3

6

4

5

A

2

1

2

B C

D E F G

32

EN

7. Now connect the wires to the terminal block on the mounting plate in the following way (G):

 • Bluewire→N

 • Brownorblackwire→L

 • Earthwire(yellow-green)→

MONTAGE - Installing the down rod onto the motor

1. Remove the cotter pin and metal pin from the down rod (see figure H).

2. Lead the down rod through the canopy (I).

3. Untighten the two screws on the motor (J).

4. Remove the cable binder from around the wiring and lead the wires through the down rod (K). Make sure

not to damage the wiring in the process.

5. Reinstall the metal pin into the down rod (L) en secure it by reinsterting the cottor pin (M).

6. Tighten the two screws on the motor (N).

The down rod has now been installed correctly.

MONTAGE - Installing the fan blades onto the motor

1. Remove the two screws from one of the red plates on the motor (see figure O), place a fan blade (white

side up) on the red plate and tighten the screws (P). Make sure to keep the red plate between the fan

blade and the motor.

2. Repeat the process for the other two fan blades.

H J KI

L

NM

33

EN

The fan blades have now been installed correctly.

MONTAGE - Installing the fan to the mounting plate

1. Lift up the fan and insert the “J-hook” on the mounting plate through one of the openings in the canopy

(see figure Q). This will leave your hands free for connecting the fan’s wiring.

2. Connect all earth wires (yellow-green) to the canopy (

, R).

O P

Q

34

EN

3. Connect the wiring coming from the down rod to the terminal block on the mounting plate in the following

way (S):

 • Bluewire→N

 • Brownandblackwires→L

R S

T

1

2

35

EN

4. Now lift the fan from the “J-hook”, place the fan over the two screws

1

in the mounting plate and tighten

the screws firmly (T).

5. Insert the two screws

2

into the mounting plate and tighten them firmly as well (T).

6. Secure the down rod as depicted in figure U.

The fan has now been installed correctly. You can now switch the mains power back on.

OPERATION - Controls

The ceiling fan has 3 speeds:

fast, medium and slow.

1. Pull the pull chain.

The fan will start at fast speed.

2. Pull the pull chain again.

The fan speed will change to medium.

3. Pull the pull chain again.

The fan speed will change to slow.

4. Pull the pull chain again.

The fan will shut off.

OPERATION - Summer/winter mode

The ceiling fan is equipped with a summer

mode and a winter mode: in summer mode

the fan will blow air directly down, creating

a cool breeze, while in winter mode the fan

will circulate the air warmed by your heating

system through the room.

1. Switch the mode switch down to use the

summer mode.

2. Switch the mode switch up to use the

winter mode.

U

36

EN

TROUBLESHOOTING

Trouble Prabable Cause Suggested Remedy

Fan will not

start.

1. The fan is connected to a light

switch which has been turned

off.

2. Fuse or circuit breaker blown

or mains power not switched

back on.

3. Loose power line connections

to the fan.

1. Check whether the light switch has been turned on.

2. Check whether the mains power has been switched on.

3. Check line wire connections to fan and switch wire

connections in switch housing.

WARNING: Make sure main power is turned off.

Fan sounds

noisy.

Fan wobbles

or shakes

excessively.

1. Mounting plate hasn’t been

installed correctly.

2. The down rod hasn’t been

secured properly.

1. Check to make sure the mounting plate is (still) firmly attached

to the ceiling. See ‘Montage - Installing the mouting plate’.

2. Check to make sure the down rod has been secured properly.

See ‘Montage - Installing the down rod to the motor’.

WARRANTY CONDITIONS

Bestron offers a 60-month warranty on this equipment against defects resulting from manufacturing and/or

material errors, subject to the following conditions.

1. No labour or material costs will be charged during this warranty period.

2. Any repairs carried out under the warranty will not extend the warranty period.

3. Faulty parts, or in the event of exchange, the faulty equipment itself, will automatically become the pro-

perty of Bestron.

4. The warranty is valid for the first buyer only and is non-transferable.

5. The warranty is not valid for damage caused by:

• Accidents

• Improper use

• Wear and tear

• Neglect

• Faulty installation

• Connection to a different mains voltage than indicated on the type plate

• Unauthorised changes

• Repairs carried out by unqualified third parties

• Use in violation with the applicable statutory, technical or safety standards

• Careless transport without suitable packaging or other protection

6. Warranty cannot be claimed:

• For damage during transport

• If the serial number of the appliance is removed or changed

7. Items excluded from warranty are:

• Cords

• Lamps

• Glass parts

8. The warranty does not entitle the purchaser to compensation for any damage other than replacement

or repair of the faulty parts. Bestron cannot in any event be held liable for any indirect or consequential

losses caused by or in relation to the equipment it has provided.

9. Claims under a warranty may only be submitted to your (online) retailer or directly to the Bestron Ser-

vice Department. Never send items without being asked to. We may refuse the parcel and you will be

liable for the costs. Contact us first and we tell you how the appliance should be packaged and sent.

Each claim under a warranty must be accompanied by the relevant receipt.

SERVICE

If an unexpected problem occurs, please contact the BESTRON service department:

www.bestron.com/service

37

EN

Page is loading ...

v190910-02

BESTRON.COM/WHATSAPP

NEED HELP? CHAT WITH US!

WHATSAPP CUSTOMER SERVICE

Bestron DT48C User manual

Bestron DT48C User manual

in other languages

Related papers

Other documents