AEROKLAS TRITON SU Installation guide

Brand
AEROKLAS
Model
TRITON SU
Type
Installation guide
CANOPY
INSTALLATION MANUAL
TRITON SU SPOILER
Installation time : 20 mins. For Spoiler
2 Put the drill-jigs into the nut.
MANUAL
Drill 3, 8, mm.
Model Number Issue Date Page
2/4
00
10 05 6//201
TRITON SU
COMPONNENT PART
Washer M6 = 3 Pcs.
Seal = 3 Pcs.
Adhesive tape = 3 Pcs.
Drill jig = 3 Pcs.
Spoiler = 1 Pcs.
Manual = 1 Pcs.
Screw M6 = 3 Pcs.
Rubber seal T1.5mm.=1set
TOOLS
No. mm.10
Cleaning cloth
1 Clean the install area with the cloth.
7 Remove seal on all adhesive tape.
5 Drill 3 mm. -diameter pilot holes into the
drill-jigs (4 position). Afterward remove
the drill-jigs. Drill 8 mm.- diameter until
through inner canopy.
4 Take off spoiler.
3 Place the spoiler with drill-jigs at install
position and stick the drill-jigs with
adhesive tape.
Page
34/
Model Number Issue Date
00
10 05 6//201
TRITON SU
300
6 Take off Rubber Plug 3 point .
Rubber seal
Adhesive tape
7mm.
SECTION: A
A
B
C
7mm.
SECTION: B,C
300
9 Inside canopy : Tighten screw set to the
nut of spoiler, (3 position).
Page
44/
Model Number Issue Date
00
10 05 6//201
TRITON SU
8 Put the spoiler into the nuts hole.
10 Put rubber-plug in the hole.
11 Install completely.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

AEROKLAS TRITON SU Installation guide

Brand
AEROKLAS
Model
TRITON SU
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents