Unbranded H4786-995-CR User manual

Brand: Unbranded

Model: H4786-995-CR

Type: User manual

INSTALLATION INSTRUCTIONS FOR 13/16” DOUBLE CORNER ROD

NOTE: Finials shown are for illustration

purposes only.

Corner Connector

Inner Rod

Back Rod

Mounting

Bracket

Front Rod

Finial Insert

Outer Rod

Finial

End Caps

Rod

Connector

on each inner rod and outer rod to prevent rod

movement when sliding curtain.

Mount at least one bracket

Adjust draperies to desired position.

Ensure to mount at least one bracket on each inner rod and outer rod to

prevent rod movement when sliding curtain.

PULL MIDDLE END CAP OUT (Back Rods)

Arrange the rod according to assemble rod (no. 3 instruction)

side by side, front and back rod just like this diagram

CORNER CONNECTOR

(28-48, 48-84, 66-120)

(120-170)

a. Pull out the middle back rod end caps

b. Insert provided plastic finial adapter

There are two diameters of white inserts

included. For a three piece rod, there is only

one diameter of white insert. (Skip this step

if inserts are already attached to rod.) Push

corresponding insert into each end of rod

with fin side going into the pole and flat end

facing out.

Attach finials by pushing and turning the

end of the finial post into the end of the finial

insert until completely snug. Rotal finial on

rod for proper alignment if required.

Place corner connector in between the rods,

insert the rod connector to one rod and loosen

the connector tightening screw. Adjust connector

to desired angle. Tighten screw on the connector

to lock angle in place. Slide the other rod onto the

open end of rod connector. Do the same for the

other rod.

8 9

1

Unbranded H4786-995-CR User manual

Brand: Unbranded

Model: H4786-995-CR

Type: User manual

Related papers

Other documents