EMOH 4701-282-CR User manual

4701-282-CR
Brand
EMOH
Model
4701-282-CR
Type
User manual
INSTALLATION INSTRUCTIONS FOR 13/16” DOUBLE CORNER ROD
NOTE: Finials shown are for illustration
purposes only.
Corner Connector
Inner Rod
Back Rod
Mounting
Bracket
Front Rod
Finial Insert
Outer Rod
Finial
End Caps
Rod
Connector
on each inner rod and outer rod to prevent rod
movement when sliding curtain.
Mount at least one bracket
Adjust draperies to desired position.
Ensure to mount at least one bracket on each inner rod and outer rod to
prevent rod movement when sliding curtain.
PULL MIDDLE END CAP OUT (Back Rods)
Arrange the rod according to assemble rod (no. 3 instruction)
side by side, front and back rod just like this diagram
CORNER CONNECTOR
(28-48, 48-84, 66-120)
(120-170)
a. Pull out the middle back rod end caps
b. Insert provided plastic finial adapter
There are two diameters of white inserts
included. For a three piece rod, there is only
one diameter of white insert. (Skip this step
if inserts are already attached to rod.) Push
corresponding insert into each end of rod
with fin side going into the pole and flat end
facing out.
Attach finials by pushing and turning the
end of the finial post into the end of the finial
insert until completely snug. Rotal finial on
rod for proper alignment if required.
Place corner connector in between the rods,
insert the rod connector to one rod and loosen
the connector tightening screw. Adjust connector
to desired angle. Tighten screw on the connector
to lock angle in place. Slide the other rod onto the
open end of rod connector. Do the same for the
other rod.
8 9
  • Page 1 1

EMOH 4701-282-CR User manual

4701-282-CR
Brand
EMOH
Model
4701-282-CR
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents