5
English4 English
the glass center portion. Close the fuse access cover (D.) by sliding the
cover back into the plug until it is completely closed, latches and is flush
with the face of the plug. Risk of fire. Do not replace attachment plug.
Contains a safety device (fuse, AFCI, LCDI) that should not be removed.
Discard product if the attachment plug is damaged.
This unit requires one (1) lithium coin cell battery (CR2032), 3 Volt
(included). DO NOT DISPOSE OF BATTERIES IN FIRE. BATTERIES MAY
EXPLODE OR LEAK.
WARNING: Keep away from children. If swallowed call (800) 222-1222 or
(202)625-3333, in Canada (416) 813-5900.
NOTE: This equipment has been tested and found to comply with
the limits for Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
This appliance has a polarized plug. (One blade is wider than the other.)
To reduce the risk of electrical shock, this plug is intended to fit in a
polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician. Do
not attempt to defeat this safety feature.
WARNING – To reduce the risk of fire or electrical shock, do not use this
product with any solid state speed control device. To reduce the risk of
fire or electric shock and injury to persons, do not use in a window.
This product employs overload protection (fuse). A blown fuse indicates
an overload or short-circuit situation. If the fuse blows, unplug the product
from the outlet. Replace the fuse as per the user servicing instructions
(follow product marking for proper fuse rating) and check the product.
If the replacement fuse blows, a short-circuit may be present and the
product should be discarded or returned to an authorized service facility
for examination and/or repair.
Do unplug your Tower Circulator before cleaning.
Do clean your Vornado Tower Circulator regularly. Refer to the
CLEANING instructions provided. Never clean the air circulator in any
manner other than as instructed in this manual.
Do Not use gasoline, thinners, solvents, ammonia or other chemicals
for cleaning.
Do Not immerse this product in water or allow water to drip into the
motor housing.
Do Not use near furnaces, fireplaces, stoves or other high-temperature
heat sources.
Do Not position this product too close to draperies because they may
be drawn into the rear grill, cutting off airflow.
Do Not use this product outdoors.
Do Not use this product on wet surfaces.
Do Not use this product in a bathtub or shower.
Do Not use this product if it has a damaged cord or plug. Discard fan or
return to an authorized service facility for examination and/or repair.
Do Not carry this product by the cord, or use the cord as a handle.
Do Not attempt to repair or replace parts.
Do Not run cord under carpeting. Do Not cover cord with throw rugs,
runners, or similar coverings. Do not route cord under furniture or
appliances. Arrange cord away from traffic area and where it will not be
tripped over.
Do Not operate the Tower Circulator on an elevated surface, such as a
shelf or desktop, use only while placed on the floor.
Do use common sense when using this product and/or any electrical
appliance.
User Servicing Instructions
Grasp plug and remove from the receptacle or other outlet device. Do
not unplug by pulling on cord. Open fuse cover (A.) by sliding access
cover on top of attachment plug towards blades. Remove fuse (B.)
carefully by gently prying out the ends of the fuse from the receptacle.
Risk of fire. Replace fuse only with 2.5 Amp, 125 Volt fuse. Contact
Vornado customer service for replacement fuse. Phone: 1-800-234-0604,
Install replacement fuse (C.) by first placing the end of the fuse into the
fuse receptacle which is opposite of the blades of the plug, then carefully
push in the other end. Only push against the metal end of the fuse, not
IMPORTANT INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING THIS TOWER.
SAVE THESE INSTRUCTIONS
A. B. C. D.
IMPORTANT INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING THIS TOWER.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) his device must accept any interference received,
including interference that may cause undesired operation.
This Class B digital apparatus complies with Canadian ICES-003. Cet
appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.