Page is loading ...
Model Number:
USER MANUAL
12” Metal Wall Fan
MWF30
Product Overview
1
2
3
4
5
67
Parts list
1 Safety Grilles
2 Fan Blades
3 Motor Housing
4 Fan Holding Arm
5 Wall-Mounting Plate
6 On/Off/Speed Pull Cord -- pull, gently, to switch on
and select the fan speed
7 Oscillation Pull Cord -- pull, gently, to activate fan
oscillation
8 8mm Wall plugs and screws -- for wall-mounting
8
Unpacking
• This product has been packaged to protect it against transportation
damage. Unpack the appliance and keep the original packaging carton
and materials in a safe place. It will help prevent any damage if the product
needs to be transported in the future, and you can use it to store the
appliance when it is not in use. In the event it is to be disposed of, please
recycle all packaging materials where possible.
• Plastic wrapping can be a suffocation hazard for babies and young
children, so ensure all packaging materials are out of their reach and
disposed of safely.
• Unwind the cord to its full length and inspect it for damage. Do not use the
appliance if the appliance or its cord have been damaged or are not working
properly. In case of damage, contact our after sales support line for
advice on examination, repair or return of the damaged product.
• Make sure you have read and understood all instructions and warnings in
this manual. Refer to the Product Overview, page 5, to familiarise yourself
with the product and identify all parts. Pay particular attention to the safety
instructions on the previous pages.
Safety grille assembly
1
Screw the four screws
out of the motor
housing.
2
Attach the rear safety
grille and fasten with
the screws you just
removed.
Getting Started
Getting Started (Cont.)
3
Insert the fan blade
assembly into the motor
shaft.
4
Tighten the screw to
control the fan blade.
Wall-mounting instructions
Now that your new 30cm Metal Wall Fan is assembled, it is ready for wall-
mounting to an appropriately sturdy wall that can support the weight of the
fan and has a power point in easy reach.
• Hold the mounting plate of the fan to the wall in the
position where you want to mount it. Mark the two
positions for the screws through the screw holes,
which should be 8.5cm apart.
• Drill two holes into the wall with an 8mm drill bit
and insert the supplied wall plugs.
• Attach the mounting plate to the wall and secure it
with the supplied 8mm screws.
• Insert the power plug into a 230V 50Hz electrical
outlet and switch on power at the outlet.
• Your new 30cm Wall Fan is now ready for use.
IMPORTANT!
• For the best airflow angle and cooling results, we suggest installing the
fan at a height of 180 to 200cm above ground.
• Ensure you are mounting the fan in a safe location on the wall; do not
mount it directly above a bed, cot or similar location.
The 30cm Wall Fan features three speeds and can be set to oscillate. Once it
is securely installed on a wall, operation is controlled by the two pull cords.
Left pull cord: On/Off/Speed
Pull the left power cord gently to switch on the fan. Pull it again to select a
different fan speed (low, medium or high), or to switch off the fan.
Right pull cord: Oscillation
Pull the right pull cord, gently, to activate fan oscillation. Pull it again to stop
oscillation.
Instructions
WARNING!
• Never attempt to touch a fan blade, or insert an object through the
safety grilles during operation -- risk of injury!
• Do not pull the cord too hard, otherwise it may break. Should this
happen, contact our after sales support centre for advice on repair or
replacement.
Other Useful Information
Cleaning and maintenance
• Dusting: Clean your fan periodically by lightly running a vacuum cleaner
nozzle (soft brush) over the front and rear grilles to remove any dust or dirt
that may have accumulated inside or on the unit. Alternatively, use a soft,
dry cloth or feather duster for dusting.
• Stubborn stains: Use a slightly damp, soapy cloth for stubborn stains but
be sure the cloth is not too wet. Use caution around the motor housing
area. Do not allow the motor or other electrical components to be exposed
to water. Dry thoroughly.
To remove dirt or stains from the blades, take the fan off the wall and
disassemble it following the wall-mounting and safety grill assembly
instructions in reverse order. Take care with the blades -- do not drop them!
Storage
• If you want to store your fan in the off season, take it off the wall and
disassemble it following the wall-mounting and safety grill assembly
instructions in reverse order.
• Keep the fan in a safe, dry location, protected from dust. We recommend
using the original carton for storage. Alternatively, place a larger plastic bag
or old towel over the top of the cleaned appliance for dust protection.
Service/repair
• The appliance requires no maintenance and contains no user-serviceable
parts. Do not attempt to take it apart, repair or modify it.
• Do not operate the fan if its power cord or plug is damaged, or when it is
working abnormally. In case of damage or malfunction, or if the cord is
damaged, have the unit repaired by appropriately qualified personnel only,
or contact the after sales support line for advice on repair or replacement.
WARNING!
• Before cleaning, maintenance or moving the fan, and before removing a
front or rear grille, switch off the fan and unplug it from the wall outlet.
• Do not immerse the fan in water or other liquids. Do not spray it with
liquids. Do not allow water to drip on or into the fan motor housing.
• Never use petrol, solvents, harsh detergents, or abrasive or alkaline
cleaners on the fan.
Other Useful Information (Cont.)
Technical specifications
Power 90W, 220-240V AC, 50Hz
Fan speeds 3 (Low - Medium - High)
Dimensions (mm) approx. 680 (H) x 360 (W) x 370 (W)
Weight approx. 6.1kg
Responsible disposal
• At the end of its working life, make the appliance unserviceable by
unplugging it from the power outlet and cutting the power cord.
• Do not throw this appliance out with your household rubbish. Electrical
and electronic products contain substances which can have a detrimental
effect on the environment and human health if disposed of inappropriately.
Observe any local regulations regarding the disposal of electrical consumer
goods and dispose of it appropriately for recycling. Contact your local
authorities for advice on recycling facilities in your area.
/
