Kozyheat Bellingham 52 Owner's manual

#HTK-BH52 AIR CHUTE INSTALL

For use with model #BHM-52

HUSSONG MANUFACTURING CO., INC.

Kit contents

(20) Sheet metal screws

1. Remove the heat transfer kit cover plate as outlined in your individual

replace manual. Save screws. See Figure 1.

EXTERIOR KIT INSTALLS (HTK-EXT): Verify the damper lays against the outer

shell of the replace when in resting position. Ensure the damper will

move freely when the fan is engaged. See Figure 2.

INTERIOR KIT INSTALLS (HTK-INT): Remove the damper from the heat

transfer kit air chute by pushing the metal tabs through the holes, and

pulling the damper out of the air chute. See Figure 3.

2. Secure the air chute to the replace using (4) sheet metal screws

previously removed and (10) sheet metal screws provided. See Figure 4.

3. Install the collar to the top of the air chute using the (4) sheet metal

screws provided. See Figure 5.

4. Save remaining screws for air duct installation of your specic

heat transfer kit. See your HTK-INT and/or HTK-EXT installation

manual.

#HTK-BH52 R.1 7.20

Figure 1, Cover Plate Removal

Figure 2, HTK-EXT Air Chute Damper

Figure 3, HTK-INT Air Chute Damper Removal

Figure 4, Air Chute Install

Remove heat transfer cover plate

Air chute for HTK-EXT installations

Do not remove damper

Damper

Remove damper for HTK-INT installations

Discard damper

Push tabs through

holes to remove damper

Holes

Tabs

Air chute with damper removed

Secure air chute Install collar