We Drive Light
This driver is to be installed in accordance with Article 450 of the
National Electric Code. The driver must be installed in a
well-ventilated area free from explosive gases and vapors.
Proper operation requires for free ow of air. As this driver is
hardwired it should only be installed by a qualied electrician.
Precautions Before Installing
• Check the label and ensure the driver has the proper input
voltage and wattage for the job. Check the wire markings to
ensure they match the wiring diagram on this installation
guide.
• If the product has any visible damage do not install it.
Mounting
Select a suitable location capable of supporting the weight of
the driver. Use the keyholes in the driver case.
Input Connections / Grounding
First, remove the input wiring cover and install the clamp
connectors. With power turned o, route the input wires and
make connections according to the wiring diagram below. For
all wire connections use only UL listed wire nuts and connectors
of suitable size and type. The driver MUST be grounded in
accordance with the N.E.C.
Output Connections
First, remove the output wiring cover and install the clamp
connectors. With power turned o, route the light xture wires
and make connections according to the wiring diagram below.
0-10V Dimming
With power turned o, route the 0-10V wires and make
connections according to the wiring diagram below.
For all wire connections use only UL listed wire nuts and
connectors of suitable size and type.
The contents of this document are subject to change without notice
If you need to quickly calculate the drop voltage
Magnigauge - The Ultimate Drop Voltage Calculator Free App
suitable for Apple and Android Devices go to
www.magnitudeinc.com/service-support/voltage-drop-app/
14711 Bentley Circle, Tustin, CA 92780 Tel: (714) 312-5080 Fax: (714) 312-5070 www.magnitudeinc.com
Compatible 0-10V Dimmer list
Dimmers
Lutron
Lutron
Lutron
Leviton
Watt Stopper
Light Olier Controls
Phillips
Part Number
Diva - DVTV
Diva - NFTV
Nova T - NTFTV
illumaTech - IP7
DCLV1
ZP600FAM120
Sunrise - SR1200ZTUNV
Quick Specs
Input Voltage Range
Input Frequency
Output Voltage
Operating Ambient Temperature
Env. Protection Rating
120 - 277VAC ± 10%
50 / 60Hz
24V DC
-25
o
c - 40
o
c
IP65
BEFORE YOU BEGIN
!
SOLIDRIVE
CONSTANT VOLTAGE 010V DIMMABLE LED DRIVER INSTALLATION GUIDE
CLASS 2
CLASS P
120-277V
E465183
IP65
24V
DC
Compatible with P/N: CVD96x24DC
rev002
White (N)
Red (+)
Black (-)
Gray
Violet
Black (L)
Green ( )
0-10V
Dimmer
LED Driver
