Homax 2614 Installation guide

Instrucciones

Instructions

™

BUILD A SAG-FREE GATE

FRAME IN 20 MINUTES!

• NoZ-bracingrequired.Noangledcutsneeded.

• Squarenotrequired.Gateframewillautomaticallybesquared

whenbracketsareattached.

• Accomodatesvarioushorizontalrailsizes:

 •2x3s•2x4s•2x6s,etc.

• Buildcustomsizedgatesoraddtopre-fabfencepanels.

• Toolsrequired:

 •Saw•ScrewDriverorScrewGun•Drill•1/8"DrillBit

A. Connect brackets to top & bottom rails:

Step 1-Put1WoodScrew(W)intoholeclosesttotheoutsideedge.

Step 2-Put1PanHeadScrew(P)intoeachlocationasmarkedin

theillustrationbelow.

B. Connect side rails:

Step 4-Connecttherightsiderailtotherighttopandbottombrack-

ets.Use2Pan Head Screws (P) for each bracket.

Step 5-Repeatonleftsiderail.

C. Connect hinges to left side rail:

Step 6-Attachthetophingetotheleftsiderailusing4 Wood

Screws (W).

Step 7-Repeatonthebottomhinge.

D. Connect Gate to Post:

Step 8-Determineifthehingeswillbeontheleftorrightsideofthe

gateopeningandwhichwaythegatewillswing.Attachthefence

boardsaccordingly.

Step 9-Attachtophingeto4x4postwith4 Wood Screws (W).

Step 10-Repeatonthebottomhinge.

Step 3-RepeatSteps1&2onthebottomrail.

NOTE: PRE-DRILL ALL SCREW HOLES WITH 1/8’’ DRILL BIT.

Step-by-Step Instructions

WoodScrews(W) PanHeadScrews(P)

Where2holesarepresentinasingle

location,useonly1screwineitherhole.

Page is loading ...

APremierBrandofTheHomaxGroup,Inc.

Bellingham,WA98227|www.homaxproducts.com|(800)729-9029

MN13286.1010

™