Sony SU-W100 Owner's manual

M90

Wall-Mount Bracket

SU-W100

4-089-491-13 (1)

Operating Instructions

• This Wall-Mount Bracket is designed for use with the Sony KLV-17HR1/

KLV-15SR1/KLV-17HR2/KLV-15SR2/KLV-17HR3 LCD Colour TV.

Bedienungsanleitung

•

Diese Wandmontagehalterung ist für die LCD-Farbfernsehgeräte KLV-

17HR1/KLV-15SR1/KLV-17HR2/KLV-15SR2/KLV-17HR3 von Sony gedacht.

Mode d’emploi

•

Ce support de fixation mural est conçu pour être utilisé avec le téléviseur couleur

LCD KLV-17HR1/KLV-15SR1/KLV-17HR2/KLV-15SR2/KLV-17HR3 Sony.

Manual de instrucciones

•

Este soporte mural de montaje ha sido diseñado para el televisor en color de pantalla de

cristal líquido KLV-17HR1/KLV-15SR1/KLV-17HR2/KLV-15SR2/KLV-17HR3 de Sony.

Istruzioni per l’uso

•

La presente staffa di montaggio a parete è stata appositamente progettata per l’uso con i televisori

con display LCD a colori KLV-17HR1/KLV-15SR1/KLV-17HR2/KLV-15SR2/KLV-17HR3 Sony.

Manual de instruções

•

Este suporte de montagem na parede foi concebido para ser utilizado com os televisores a cores

com ecrã LCD, modelos KLV-17HR1/KLV-15SR1/KLV-17HR2/KLV-15SR2/KLV-17HR3 da Sony.

Gebruiksaanwijzing

• Deze wandmontagesteun is ontworpen voor de Sony KLV-17HR1/KLV-

15SR1/KLV-17HR2/KLV-15SR2/KLV-17HR3 LCD-kleurentelevisie.

Bruksanvisning

• Det här väggfästet är avsett att användas med Sony KLV-17HR1/KLV-

15SR1/KLV-17HR2/KLV-15SR2/KLV-17HR3 LCD färg-TV.

Käyttöohje

•

Tämä seinäasennuskiinnitin on tarkoitettu käytettäväksi Sony KLV-17HR1-, KLV-

15SR1-, KLV-17HR2-, KLV-15SR2- ja KLV-17HR3-nestekideväritelevisioiden kanssa.

GB

DE

FR

ES

IT

PT

NL

SE

FI

2

WARNING

To avoid risk of serious injury or damage to the TV caused by dropping it,

observe the following precautions.

• Do not hang from the TV or the Wall-Mount Bracket installed on the wall.

• Be careful not to trap the AC power adapter cord of the TV when you secure

the TV to the Wall-Mount Bracket.

• Follow the installation procedures and installation direction described in this

manual.

For a safety installation, consult your Sony dealer or qualified service

personnel.

• Before installing, confirm that the wall has sufficient strength to support the

TV and the Wall-Mount Bracket. The installation location should be a flat,

perpendicular wall with a reinforcing material inside.

• Do not apply a weight other than the TV to the Wall-Mount Bracket installed

on the wall.

• Do not disassemble, modify or change the parts of the Wall-Mount Bracket.

Caution

• This Wall-Mount Bracket is only for the specified Sony LCD Colour TVs.

Do not use the bracket with a TV whose operating instructions do not specify

the use of this bracket.

• Be especially careful not to drop the TV when you install it high on a wall.

3

Installation

For secure and safety installation of the product, we recommend that you

consult your Sony dealer or qualified service personnel before you start the

installation.

For the installation, have ready six commercially available mounting screws,

anchor bolts, etc. that are appropriate for the wall.

The type and length of the screws required depend on the material and

strength of the wall. If you do not know which material your wall is made of,

consult your Sony dealer or qualified service personnel.

Step 1: Check the parts

Check all the parts are included in the package.

Step 2: Decide the installation location

Decide the location on the wall to install the TV.

Then, place bracket A on the installation location and mark the four screw

holes on the wall using a pencil.

Before marking, make sure that the distance between the upper edge of bracket

A and the ceiling and that between the side edge of bracket A and the side

wall are 20 cm or more.

Note

Attach bracket A level with the floor.

Bracket A (1) Bracket B (1) Screw (2)

continued

Bracket A

Ceiling

20 cm or more

Wall

Mark this

portion using

a pencil.

GB

20 cm or more

4

Step 3: Secure bracket A to the wall

1

Insert four of the screws you prepared at the positions

marked in Step 2 (page 3).

Do not tighten the screws completely for the moment. Keep a space of 2

to 3 mm from the wall.

2

Press bracket A to the wall and slide it down. Then fully

tighten the four screws on the wall.

3

Fully tighten two of the screws you prepared in screws

holes 1 and 2 firmly.

Screws you

prepared

Wall

2 - 3 mm

,

Wall

Bracket A

Screws you

prepared

Bracket A

Wall

Bracket A

5

Step 4: Attach bracket B to the TV

Before attaching bracket B, disconnect the AC power adapter and all the

cables from the TV.

For how to remove the rear cover of the TV, refer to the Operating Instructions

supplied with the TV.

(The illustrations used in this manual show the KLV-15SR1 as an example.)

1

Remove the four screws as illustrated below, and detach

the TV stand from the TV.

To prevent damaging the surface of the LCD display, place the TV on a

soft mat.

Notes

• Place the TV body only on the table as illustrated above. If the TV stand is also on

the table level to the TV body, the TV body may become unstable and cause

damage.

• When removing the TV stand, hold it firmly.

2

Secure bracket B to the TV firmly using the four screws

removed in step 1.

Soft mat

Rear of the TV

Remove these screws.

TV stand

Table

Rear of the TV

Bracket B

continued

6

Step 5: Connect the cables to the TV

Before securing the TV to the wall, connect the

cables to the TV.

You can arrange the cables by passing them

along the sides of bracket B.

Note

Do not replace the rear cover of the TV for the moment.

Step 6: Secure the TV to the wall

1

Hook bracket B on bracket A.

Notes

• Secure the TV to the wall without the rear cover.

• Hold the TV firmly. Be especially careful when you secure the TV in a high place.

2

Align the screw holes on

bracket B with those on

bracket A, and fully tighten

the supplied two screws

using a coin or similar.

Note

To prevent the TV being dropped, hold

the TV firmly as illustrated and tighten

the screws.

Bracket B

Bracket A

Wall

Bracket B Bracket A

Bottom view

Wall

Bracket A

Two screws

(supplied)

7

Step 7: Adjust the TV angle for easy viewing

You can tilt the TV up to about 15°

forward.

Note

When adjusting the angle, be sure to hold both

sides of the TV.

Step 8: Replace the rear cover on the TV

For details on how to replace the rear cover, refer to the Operating Instructions

of the TV.

Detaching the TV from the Wall-Mount Bracket

To detach the TV, remove the rear cover from the TV, then remove the two

screws.

Specifications

Bracket mass: Approx. 0.9 kg

Supportable weight: Approx. 10 kg

Design and specifications are subject

to change without notice.

235 mm

160 mm

62 mm

Page is loading ...

Sony Corporation Printed in Japan

Sony SU-W100 Owner's manual

Related papers

Other documents