Page is loading ...
Manual # 650388B
VHX-58C-VET
Dakota Digital VHX Instrument Installation
For 1958-‘62 Corvette
Your new VHX-58C-VET kit includes:
Installation
Control Box
CAT5 Cable
Universal Sender
Pack
Installation Manuals
VHX Display
1. Remove the stock housing from the dash and remove the original gauges from the housing. Save
all hardware for reassembly.
Switch Assembly
Manual # 650388B
2. First mount the tachometer in the
center round opening. Using
factory hardware, fasten the tach
in the original housing using the
two mounting tabs on the back of
the tach housing.
3. The next step is mounting the speedometer. With
the bracket already attached to the speedometer
housing, align the aluminum bracket to the stud at
the top of the original housing and fasten it in
place using stock hardware. Tighten the two
lower tabs with the stock hardware.
4. The Fuel/Temp and Volts/Oil clusters can now
be mounted to the ‘Vette housing using the
factory hardware. When looking from the back,
Volts/Oil will be on the left side and Fuel/Temp
will be on the right side.
Manual # 650388B
5. Connect the CAT5 cable to the back of the speedometer as the assembled housing
is reinstalled into the dash. Take care when routing the CAT5 cable to the control
box.
5. Next, connect the ribbon cables. These are labeled and have male and female
connectors. Example: Oil female connector to Oil male connector
Manual # 650388B
WARNING: This product can expose you to chemicals including lead, which is known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to
www.P65Warnings.ca.gov
7. Refer to the main manual for wiring instructions to complete the VHX installation.
/