Dell Precision 360 Quick start guide

www.dell.com | support.dell.com

Dell Precision™ Workstation 360

Setup and Quick Reference

Guide

Models: DHM and WHM

Notes, Notices, and Cautions

NOTE: A NOTE indicates important information that helps you make better use of your

computer.

NOTICE: A NOTICE indicates either potential damage to hardware or loss of data and tells you

how to avoid the problem.

CAUTION: A CAUTION indicates a potential for property damage,

personal injury, or death.

Abbreviations and Acronyms

For a complete list of abbreviations and acronyms, see the “Glossary” in the User’s Guide.

____________________

Information in this document is subject to change without notice.

Reproduction in any manner whatsoever without the written permission of Dell Computer Corporation is strictly

forbidden.

Trademarks used in this text: Dell, the DELL logo, and Dell Precision are trademarks of Dell Computer Corporation;

Microsoft, Windows, and Windows NT are registered trademarks of Microsoft Corporation.

Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and

names or their products. Dell Computer Corporation disclaims any proprietary interest in trademarks and trade names

other than its own.

Models: DHM and WHM

February 2003 P/N D0732 Rev. A00

Contents 3

Contents

Finding Information for Your Computer . . . . . . . . . . . . . . 5

Setting Up Your Computer

. . . . . . . . . . . . . . . . . . . . . 8

Monitor Connections

. . . . . . . . . . . . . . . . . . . . . . . 14

Completed Setup

. . . . . . . . . . . . . . . . . . . . . . . . . 16

Opening the Computer Cover

. . . . . . . . . . . . . . . . . . . 17

Inside Your Computer

. . . . . . . . . . . . . . . . . . . . . . . 19

Solving Problems

. . . . . . . . . . . . . . . . . . . . . . . . . 21

Resolving Software and Hardware Incompatibilities

. . . . . . 21

Using System Restore in Windows XP

. . . . . . . . . . . . . 23

Using the Last Known Good Configuration in Windows 2000

. . 24

When to Use the Dell Diagnostics

. . . . . . . . . . . . . . . 24

Starting the Dell Diagnostics

. . . . . . . . . . . . . . . . . . 25

Beep Codes

. . . . . . . . . . . . . . . . . . . . . . . . . . 27

Error Messages

. . . . . . . . . . . . . . . . . . . . . . . . 28

System Lights

. . . . . . . . . . . . . . . . . . . . . . . . . 28

Diagnostic Lights

. . . . . . . . . . . . . . . . . . . . . . . 30

Frequently Asked Questions . . . . . . . . . . . . . . . . . . . . 33

Page is loading ...

Setup and Quick Reference Guide 5

Finding Information for Your Computer

Dell provides the following resource and support tools. Additional resources may be shipped

with your computer.

What are you looking for? Find It Here

• A diagnostic program for my computer

• Drivers for my computer

•My User’s Guide

• My device documentation

Drivers and Utilities CD

(also known as the ResourceCD)

Documentation and drivers are already

installed on your computer when shipped

from Dell. You can use the CD to reinstall

drivers, run the Dell Diagnostics, or access

your documentation.

Readme files may be included on your CD

to provide last-minute updates about

technical changes to your computer or

advanced technical-reference material for

experienced users or technicians.

• System board connectors

• Location of system board components

System Information Label

Located on the inside of your computer cover.

or

6 Setup and Quick Reference Guide

www.dell.com | support.dell.com

• Warranty Information

• Safety Information

Dell System Information Guide

• How to remove and replace parts

• Technical specifications

• How to configure system settings

• How to troubleshoot and solve problems

User’s Guide Icon (Microsoft

®

Windows

®

2000)

Double-click the User’s Guides icon on your desktop.

Windows XP Help and Support Center

1

Click the Start button and click Help and Support.

2 Click User’s and system guides and click User’s guides.

• Express Service Code and Service Tag

• Windows

License Label

Express Service Code and Product Key Label

These labels are located on your computer.

• Latest drivers for my computer

• Answers to technical service and support

questions

• Online discussions with other users and

technical support

• Documentation for my computer

including the Service Manual

Dell Support Website — support.dell.com

The Dell Support website provides several online tools, including:

• Solutions — Troubleshooting hints and tips, articles from

technicians, and online courses

• Community Forum — Online discussion with other Dell customers

• Upgrades — Upgrade information for components, such as memory,

the hard drive, and the operating system

• Customer Care — Contact information, order status, warranty,

and repair information

• Downloads — Drivers, patches, and software updates

• Reference — Computer documentation, product specifications,

and white papers

What are you looking for? Find It Here

Setup and Quick Reference Guide 7

• Service call status and support history

• Top technical issues for my computer

• Frequently asked questions

• File downloads

• Details on my computer configuration

• Service contract for my computer

Dell Premier Support Website —

premiersupport.dell.com

The Dell Premier Support website is customized for corporate,

government, and education customers. This website may not be

available in all regions.

• How to use Windows XP

• Documentation for my computer

• Documentation for devices

(such as a modem)

Windows XP Help and Support Center

1 Click the Start button and click Help and Support.

2 Type a word or phrase that describes your problem

and click the arrow icon.

3 Click the topic that describes your problem.

4 Follow the instructions on the screen.

• How to reinstall my operating system Operating System CD

After you reinstall the operating system

using the Operating System

Reinstallation CD, use the Drivers and

Utilities CD to reinstall drivers for the

devices that came with your computer.

The product key for your operating

system is located on your computer.

What are you looking for? Find It Here

or

8 Setup and Quick Reference Guide

www.dell.com | support.dell.com

Setting Up Your Computer

CAUTION: Before performing any of the procedures in this section,

follow the safety instructions in the System Information Guide.

NOTICE: If your computer has an expansion card installed (such as a network card), connect

the appropriate cable to the card, not to the connector on the computer back panel.

You must complete all steps to properly set up your computer. See the appropriate figures

that follow the instructions.

1 Connect the keyboard and mouse.

NOTICE: Do not attempt to operate a PS/2 mouse and a USB mouse simultaneously.

2 Connect the modem or network cable.

Insert the network cable, not the phone line, into the network connector. If you have

an optional modem, connect the phone line to the modem.

NOTICE: Do not connect a modem cable to the network adapter. Voltage from telephone

communications can cause damage to the network adapter.

3

Connect the monitor.

Align and gently insert the monitor cable to avoid bending connector pins. Tighten

the thumbscrews on the cable connectors.

NOTE: Some flat-panel displays and graphic cards support Digital Visual Interface (DVI). If

your monitor and card have DVI connectors, Dell recommends that you use DVI instead of VGA.

A second monitor is optional and requires a multimonitor graphics adapter card. To

enable dual-monitor support, both monitors must be attached when the computer

starts. See “Monitor Connections” on page 14 for more information on attaching two

monitors.

4 Connect the speakers.

5 Connect power cables to the computer, monitor, and devices and insert the other ends

of the power cables to electrical outlets.

Setup and Quick Reference Guide 9

6 Verify that the voltage selection switch is set correctly for your location.

Your computer is equipped with one of the following:

• A fixed-voltage power supply — Computers with a fixed-voltage power supply

do not have a voltage selection switch on the back panel and operate at only

one voltage (see the regulatory label on the outside of the computer for its

operating voltage).

• An auto-sensing voltage circuit — Computers with an auto-sensing voltage circuit

do not have a voltage selection switch on the back panel and automatically detect

the correct operating voltage.

• A manual voltage selection switch — Computers with a voltage selection switch

on the back panel must be manually set to operate at the correct operating

voltage.

NOTICE: To help avoid damaging a computer with a manual voltage selection switch, set the

switch for the voltage that most closely matches the AC power available in your location. For

Japan, the voltage selection switch must be set to the 115-V position even though the AC power

available in Japan is 100 V. Also, ensure that your monitor and attached devices are electrically

rated to operate with the AC power available in your location.

7

Press the power buttons to turn on the computer and monitors.

See “Completed Setup” on page 16.

NOTE: Before you install any devices or software that did not ship with your computer, read the

documentation that came with the software or device, or contact the vendor to verify that the

software or device is compatible with your computer and operating system.

10 Setup and Quick Reference Guide

www.dell.com | support.dell.com

Mini-Tower Setup — Without Expansion Cards

keyboard

mouse

speakers

headphones

network

USB

Setup and Quick Reference Guide 11

Mini-Tower Setup — With Expansion Card

NOTE: For more information on setting up monitors with your specific graphics card,

see “Monitor Connections” on page 14.

monitor

flat-panel

monitor

speakers

network

12 Setup and Quick Reference Guide

www.dell.com | support.dell.com

Desktop Setup — Without Expansion Cards

keyboard

mouse

speakers

headphones

network

USB

Setup and Quick Reference Guide 13

Desktop Setup — With Expansion Cards

NOTE: For more information on setting up two monitors, see “Monitor Connections”

on page 14.

monitor

flat-panel

monitor

speakers

network

14 Setup and Quick Reference Guide

www.dell.com | support.dell.com

Monitor Connections

For dual monitor capable cards with a single connector

Dual VGA Y Cable Adapter

• This adapter cable can support one or two VGA

monitors. The cable is color coded: blue for the

primary monitor and black for an optional secondary

monitor.

Dual DVI Y Cable Adapter

• This adapter cable can support one or two DVI

monitors. The cable is color coded: blue for the

primary monitor and black for an optional secondary

monitor.

NOTICE: The Y Cable Adapter provided with your computer is unique to the graphics card in your computer.

Adapter cables from other graphics cards should not be used.

VGA

DVI

Setup and Quick Reference Guide 15

For dual-monitor capable cards with 1 DVI and 1 VGA connector

Single DVI/Single VGA

• Use the appropriate connector when you connect

to one or two monitors.

Dual VGA With VGA Adapter

• Use the VGA adapter when you want to connect

to two VGA monitors.

For dual-monitor capable cards with 2 DVI connectors

Dual DVI

• Use the DVI connectors to

connect to one or two DVI

monitors.

Dual DVI With One VGA Adapter

• Use the VGA adapter to connect

a VGA monitor to one DVI

connector.

Dual DVI With Two VGA Adapters

• Use two VGA adapters to

connect two VGA monitors

to the DVI connectors.

DVI

VGA

DVI

VGA

16 Setup and Quick Reference Guide

www.dell.com | support.dell.com

Completed Setup

power

Microsoft Windows Product Key

Setup and Quick Reference Guide 17

Opening the Computer Cover

CAUTION: Before performing any of the procedures in this section, follow the

safety instructions in the System Information Guide.

1

Shut down the computer through the Start menu.

2 Ensure that your computer and attached devices are turned off. If your computer and

attached devices did not automatically turn off when you shut down your computer,

turn them off now.

NOTICE: To disconnect a network cable, first unplug the cable from your computer and then

unplug it from the network wall jack.

3

Disconnect any telephone or telecommunication lines from the computer.

4 Disconnect your computer and all attached devices from electrical outlets, and then

press the power button to ground the system board.

5 If you have installed a padlock through the padlock ring on the back panel, remove the

padlock.

CAUTION: To guard against electrical shock, always unplug your computer from

the electrical outlet before opening the cover.

6

Lay the computer on its side as shown in the illustration.

NOTICE: Ensure that sufficient space exists to accommodate the open cover—at least 30 cm

(1 ft) of desktop space.

7

Open the computer cover.

– For the mini-tower, push the buttons on both ends and lift the cover open.

– For the desktop, slide the cover release latch toward the power supply of the

computer. Raise the cover, and pivot it toward the front of the computer.

18 Setup and Quick Reference Guide

www.dell.com | support.dell.com

8 Ground yourself by touching an unpainted metal surface on the computer, such as the

metal at the back of the computer, before touching anything inside your computer.

While you work, periodically touch any unpainted metal surface on the computer to

dissipate any static electricity that could harm internal components.

Setup and Quick Reference Guide 19

Inside Your Computer

Mini-Tower Computer

floppy drive

removable media drive

hard drive

power supply

system board

optional speaker

chassis intrusion

switch

AGP and PCI expansion-card slots

back-panel

connectors

power

connector

padlock ring

microprocessor airflow shroud

20 Setup and Quick Reference Guide

www.dell.com | support.dell.com

Desktop Computer

floppy drive

removable media drive

hard drive

power supply

system board

chassis

intrusion switch

AGP and PCI expansion-card slots

back-panel

connectors

power

connector

padlock ring

microprocessor airflow shroud

Setup and Quick Reference Guide 21

Solving Problems

Resolving Software and Hardware Incompatibilities

Microsoft

®

Windows

®

XP

Windows XP IRQ conflicts occur if a device either is not detected during the operating

system setup or is detected but incorrectly configured.

To check for conflicts on a computer running Windows XP:

1 Click the Start button and click Control Panel.

2 Click Performance and Maintenance and click System.

3 Click the Hardware tab and click Device Manager.

4 In the Device Manager list, check for conflicts with the other devices.

Conflicts are indicated by a yellow exclamation point (

!) beside the conflicting device

or a red

X if the device has been disabled.

5 Double-click any conflict to display the Properties window.

If an IRQ conflict exists, the Device status area in the Properties window reports the

cards or devices that share the device's IRQ.

6 Resolve conflicts by reconfiguring the devices or removing the devices from the Device

Manager.

To use the Windows XP Hardware Troubleshooter:

1 Click the Start button and click Help and Support.

2 Ty pe hardware troubleshooter in the Search field, and click the arrow to start the

search.

3 Click Hardware Troubleshooter in the Search Results list.

4 In the Hardware Troubleshooter list, click I need to resolve a hardware conflict on my

computer, and then click Next.

Page is loading ...

Dell Precision 360 Quick start guide

Dell Precision 360 Quick start guide

in other languages

Related papers

Other documents