PROLiNK DS-3301 is a smart IR controller that allows you to control your home appliances using your smartphone. With its user-friendly app, you can easily set up the device and control your appliances from anywhere, as long as you have an internet connection. The DS-3301 supports both Wi-Fi and AP modes for flexible connectivity. It's compatible with a wide range of IR-controlled devices, including TVs, air conditioners, fans, and more. The device also features a built-in learning function, allowing you to teach it new commands and customize your smart home experience.
PROLiNK DS-3301 is a smart IR controller that allows you to control your home appliances using your smartphone. With its user-friendly app, you can easily set up the device and control your appliances from anywhere, as long as you have an internet connection. The DS-3301 supports both Wi-Fi and AP modes for flexible connectivity. It's compatible with a wide range of IR-controlled devices, including TVs, air conditioners, fans, and more. The device also features a built-in learning function, allowing you to teach it new commands and customize your smart home experience.
Smart IR Controller
Version 1.00
(English / Indonesia)
Quick Installation Guide
DS-3301
2. Overview | Penjelasan 3. Installation | Instalasi
LED Status
LED Behavior |
Perilaku LED
Fast Blinking
Berkedip Cepat
Slow Blinking
Berkedip Lambat
Ready for AP Mode Configuration (Setup)
Siap untuk pengaturan lewat AP Mode Configuration
Sending IR signal over to controlled device
Mengirim sinyal IR ke perangkat yang dikendalikan
Blink once
Berkedip satu kali
Off
Off
1. Device is currently off, or
Perangkat sedang off, atau
2. Device is on standby mode waiting for command
Perangkat dalam standby mode menunggu perintah
Ready for Wi-Fi Mode Configuration (Setup)
Siap untuk pengaturan lewat WiFi Mode Configuration
Description | Deskripsi
Activity | Aktivitas
To reset the Smart IR Controller to factory default
Untuk mereset Smart IR Controller ke default pabrik
To switch between Wi-Fi Mode Configuration and
AP Mode Configuration
Untuk beralih di antara Wi-Fi Mode Configuration
dan AP Mode Configuration
Press and hold for 6 seconds
Tekan dan tahan selama 6 detik
Press and hold for 6 seconds
Tekan dan tahan selama 6 detik
Action Required |
Tindakan yang diperlukan
Reset Button
3. Installation | Instalasi
A. Preparation | Persiapan
1. Place the Smart IR Controller within three feet of the router.
Tempatkan Smart IR Controller dan ponsel sekitar 3 kaki dari router.
Note | Catatan:
- Make sure the phone is connected to the router wirelessly.
Pastikan ponsel terhubung ke router secara wireless.
- Smart IR Controller setup is operating only at 2.4GHz
Wireless N standard.
Operasi pengaturan Smart IR Controller hanya bisa dilakukan
lewat 2.4GHz Wireless N standard.
2. Download, install and create an account through PROLiNK mEzee
App. Scan below QR code to download from Google Store or Apple
App Store. Alternatively, search for “PROLiNK mEzee”.
Unduh, instal, dan buat akun melalui PROLiNK mEzee App. Pindai
kode QR di bawah ini untuk mengunduh dari Google Store atau
Apple App Store. Atau, cari "PROLiNK mEzee".
B. Setting up Smart IR Controller | Pengaturan Smart IR Controller
1. Plug the Smart IR Controller device with the provided micro-USB
cable into any power source with output rating DC 5V, 1A.
Make sure the Status LED is flashing rapidly.
Pasang perangkat Smart IR Controller dengan kabel micro-USB yang
disediakan ke sumber daya apa pun dengan peringkat output
DC 5V, 1A. Pastikan LED Status berkedip cepat.
2. Launch the mEzee App and login with your account.
Luncurkan Aplikasi mEzee dan masuk dengan akun Anda.
3. Tap “Add Device” or “+” on the top right-hand corner.
Tekan “Tambah Perangkat” atau “+” di sudut kanan atas.
4. Select “Universal Remote Control” to add Smart IR Controller.
Pilih "Universal Remote Control" untuk menambahkan Smart IR
Controller.
5. Proceed with the Smart IR Controller setting through either
Method A Wi-Fi Mode Configuration or Method B AP Mode
Configuration
3. Installation | Instalasi 3. Installation | Instalasi
Method A: Wi-Fi Mode Configuration
1. Package Contents | Isi Kemasan
Note | Catatan:
1. The picture illlustrations in this document may appear different from
actual product.
Ilustrasi gambar dalam dokumen ini mungkin tampak berbeda dari
produk yang sebenarnya.
2. If any of the stated items above are not included in your package, please
consult your reseller immediately.
Jika salah satu item yang disebutkan di atas tidak termasuk dalam paket
Anda, silakan segera berkonsultasi dengan pengecer Anda.
2. Overview | Penjelasan
Top View
Pandangan Atas
Front View
Tampak Depan
Bottom View
Tampilan Bawah
2
3
1
1. Status LED indicator | Indikator LED Status
2. Reset Button | Reset Button
3. Micro USB input | Input USB Micro
a. 1 x unit of DS-3301 | 1 x unit DS-3301
b. 1 x User Manual | 1 x Buku Panduan
c. 1 x Micro USB Cable | 1 x Kabel USB Mikro
2. Enter your Wi-Fi Password and tap Confirm.
3. Once connected, proceed to name this device for easy reference
and tap “Done”. Note that once the unit is setup, the Status LED
will stop blinking.
1 2 3 4 5 6
Lanjutkan dengan pengaturan Smart IR Controller melalui Metode A
Wi-Fi Mode Configuration atau Metode B AP Mode Configuration.
1. Make sure the Status LED is fast blinking for Wi-Fi Mode Configuration.
Otherwise, Press and hold Power Button for 6 seconds to change
the setup mode to Wi-Fi Mode configuration setup.
Pastikan LED Status berkedip cepat untuk Konfigurasi Wi-Fi. Jika
tidak, tekan dan tahan Tombol Reset selama 6 detik untuk mengubah
setup mode perangkat ke Wi-Fi Configuration.
Masukkan kata sandi Wi-Fi Anda dan tekan tombol Confirm.
Setelah terhubung, lanjutkan untuk memberi nama perangkat ini
untuk lebih mudah di referensi dan tekan tombol "Done". Perhatikan
bahwa setelah unit disetup, Status LED akan berhenti berkedip.
3. Installation | Instalasi 3. Installation | Instalasi
2. Enter your Wi-Fi Password and tap Confirm.
Masukkan kata sandi Wi-Fi Anda dan tekan tombol Confirm.
3. Tap “Go to Connect”
Tekan tombol “Go to Connect”.
4. Use your Mobile phone Wi-Fi Setting to find the Smart IR Controller SSID
“SmartLife-XXXX” and connect to the SSID. Then return back to the App.
5. Once connected, enter your Device Name and tap “Done”. Note
that once the unit is setup, the Status LED will stop blinking.
Worldwide Customer Care Centers
PROLiNK
®
is a trademark of FIDA INTERNATIONAL (S) PTE LTD and is manufactured under its authority. All other brands,
products, services, logos and company names mentioned herein are trademarks of their respective owners. All specifications,
designs and contents are subject to changes without prior notice. © Copyright 2020. PROLiNK
®
all rights reserved.
Register Online For Your Product Warranty @ www.prolink2u.com/register
INDONESIA Office
PT PROLiNK INTIDATA NUSANTARA
Walk-In : Jl. Cideng Barat No. 79, Jakarta Pusat 10150, Indonesia.
Telephone : +62 21 3483 1777
Email Support : [email protected]
MALAYSIA Office
FIDA SYSTEMS (M) SDN BHD
Walk-In : 29 Jalan USJ 1/31, 47600 Subang Jaya,
Selangor Darul Ehsan, Malaysia.
Telephone : +60 3 8024 9151
Email Support : [email protected]
SINGAPORE Office
FIDA INTERNATIONAL (S) PTE LTD
Walk-In : Block 16 Kallang Place #06-02,
Kallang Basin Industrial Estate, Singapore 339156.
Telephone : +65 6357 0668
Email Support : [email protected]
Technical Support Hotline
INDONESIA : +62 21 3483 1717
MALAYSIA : +60 3 8023 9151
SINGAPORE : +65 6357 0666
Note: Closed on Saturdays, Sundays and local/regional Public Holidays.
7 8 9
3. Installation | Instalasi
Method B: AP Mode Configuration
1. Select “AP Mode” and make sure the Status LED is blinking slow for
AP Mode Configuration. Press and hold Power Button for 6 seconds
to change to AP Mode Configuration setup when the device’s Status
LED is in Fast Blinking mode.
Pilih "AP Mode" dan pastikan LED Status berkedip lambat untuk Konfigurasi
Mode AP. Tekan dan tahan Tombol Power selama 6 detik untuk mengubah
ke pengaturan AP Mode ketika Status LED perangkat dalam mode Fast
Blinking.
Setelah terhubung, lanjutkan untuk memberi nama perangkat ini untuk
lebih mudah di referensi dan tekan tombol "Done". Perhatikan bahwa
setelah unit disetup, Status LED akan berhenti berkedip.
Gunakan settings Wi-Fi ponsel Anda untuk mencari Smart IR Controller SSID
“SmartLife-XXXX” dan konek ke SSID tersebut. Kemudian kembali ke App.
-
1
-
2
PROLiNK DS-3301 is a smart IR controller that allows you to control your home appliances using your smartphone. With its user-friendly app, you can easily set up the device and control your appliances from anywhere, as long as you have an internet connection. The DS-3301 supports both Wi-Fi and AP modes for flexible connectivity. It's compatible with a wide range of IR-controlled devices, including TVs, air conditioners, fans, and more. The device also features a built-in learning function, allowing you to teach it new commands and customize your smart home experience.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
PROLINK DS-3201 User guide
-
PROLINK GM-1001 User manual
-
-
-
-
-
-
-
-
