S.R.Smith Backstroke Start Training Device Installation guide

  • Hello! I've reviewed the provided document which appears to be installation instructions for the SR Smith Backstroke Start Training Device model 03-650T. This device is designed to attach to any standard starting block, allowing swimmers to practice backstroke starts. The instructions detail how to securely fasten the device using cam buckles. I'm ready to answer any questions you have about this product.
  • Is the device ready to use out of the box?
    Can this device be used in official FINA competitions?
    How does the device attach to the starting block?
06-832 MAY 2020
The Backstroke Start Training Device (Part Number 03-650T) is intended for training use,
but may be used in FINA competition if set at proper water depth.
Introduction
The Backstroke Start Training Device fastens to the post of any starting block, allowing swimmers of all
ages to practice backstroke launches. This device does not require additional assembly.
Backstroke Start Training Device
Part Number 03-650T
INSTALLATION INSTRUCTIONS
2
Cam Buckle Use
1. Loop straps around post (or
posts) of starting block.
Ensure the buckle pad faces
the posts.
2. Press the thumb release with
thumb.
3. Thread the opposite strap
through underside of buckle.
4. Pull tight so that backstroke
ledge is at water level and
tight to starting platform.
Wrap cam buckle strap
around post if it is too long to
tighten.
/