PARTS

1x Seat

5x Nuts and Bolts

4x Lower Legs

2x Upper Legs

HOW TO ASSEMBLE

1. Place seat upside down on a level surface and place the rst Upper Leg into position to match holes on the underneath of the seat.

2. Put a nut on to the bolt and secure the Upper Leg into place on the seat.

3. Place the second Upper Leg into position and secure with the nuts and bolts.

Bath Swivel Seat

Model No. 7293

Please read carefully before use and keep for future reference

TECHNICAL SPECIFICATION

Measurements: 32x32x34 to 52cm

Material: aluminum

Max baring Weight: 113kgs

To Clean: clean with mild soap and rinse under warm water. Wipe dry after cleaning.

To keep in good condition, wipe the seat dry after each use.

• Use caution when entering and exiting bath.

• Inspect all parts for damage before assembly.

• Make certain that the height-adjusting snap buttons fully protrude through the same respective hole of each leg extension. This will ensure that the leg extensions are

securely locked in position and an even height is achieved.

• Check the rubber tips on the leg extensions for rips, wear or if they are missing. Immediately replace any or all if any of these imperfections exist.

• All four leg extensions with rubber tips MUST touch the oor together at all times.

• DO NOT stand on chair.

• This is not a toy.

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and

knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not