Blue Sea Systems 1003100 Operating instructions

Blue Sea Systems

Bellingham, WA 98226 USA

p 360

738.8230

p 800.222.7617 USA and Canada

f 360

734.4195

www.bluesea.com

COMPRESSION

RING

STAINLESS

STEEL CAP

CableClam Installation Instructions

PN 1001100 / 1002100 / 1003100

DECK RING

GASKET

SEAL

CABLE

1. Determine if pre-drilled rubber seal offers tight fit on cable.

2. Drill a hole in the seal that ensures a tight fit with the cable.

3. Slit the seal from its edge to the drilled hole.

4. Fasten the deck ring and gasket to the surface.

5. Pass the cable end through the stainless steel cap.

6. Slip the compression ring onto the cable. Insert the cable through the slit of the seal.

Press the seal into the compression ring.

7. Screw the compression ring to the deck ring by tightening each screw a few turns

at a time. Do not overtighten the screws.

8. Press the stainless steel cap over the assembly.

This manual is also suitable for

Download PDF