Sennheiser PX 200W User manual

Step 1

First slide the earcups upwards to make the

headphones as compact as possible.

Step 2

Holding the headphones with the left side

(marked L) in the left hand and the right side

(marked R) in the right hand, turn the earcups

inwards, away from you, thus “flattening” the

headphones.

Step 3

Now fold the headphones inwards starting first

with the left side followed then by the right

side.

Step 4

There’s a notch cut into the side of each head-

band. Match the notches up and lock them into

place. (If they don’t lock, you’ve probably fol-

ded the wrong side first. Try again, starting

with the other side).

Step 5

To protect them safely when travelling, careful-

ly slip them into the case, headband first, with

the ear pads facing down towards the black

underside of the case. Turn the case over, pull

the cable toggle up, curl the cable over the

plastic clip and wrap around the case. You’ll

find a convenient alignment groove at the back

to help you. Don’t forget to tuck the plug secu-

rely in and then close the case.