D
E
Package Contents:
(1) GB014-SBH - Mini windshield suction or dash swivel mount
(1) CC005-IP - Custom cradle for Apple iPhone
(1) AP013 - Adhesive circular disc
(1) Alcohol cleaning pad
Compatible with:
• Apple iPhone 3G and Original iPhone
!
Safety Precautions
Do not install Arkon products over an air bag cover or within the air
bag deployment zone. Arkon Resources, Inc. assumes no responsi-
bility of liability for injury or death as a result of car crashes and / or
air bag deployment.
Arkon is not responsible for any damages caused to your car, your
device, or yourself due to the installation or use of this pedestal mount.
The Mobile Mounting Specialists™
Consumer Hotline:
USA (800) 841-0884
INT’L (626) 254-9005
Monday - Friday 9 am - 5 pm, PST
Do not place mount in or near an air bag deployment zone
or where it will obstruct view of the road.
!
Windshield Mount Installation Dash or Console Mounting (Optional)
Step 1.
Step 2.
Step 1.
Step 2.
IPM115
|
Mini Windshield / Dash Swivel Mount for Apple® iPhone™
GN014-SBH
Mini Windshield /
Dash Swivel Mount
CC005-IP
Custom Cradle
for iPhone
AP013
Adhesive Disc
Patent Pending
Patented
www.arkon.com
Arcadia, CA 91006 USA
Designed in USA | Made in China and Taiwan
© Copyright 2010 Arkon Resources, Inc.
Apple brand name and iPhone product name are trademarks or registered trademarks
of Apple, Inc. Arkon Resources, Inc. is not a liated with Apple, Inc.
Find a safe location on the dash or console. Use the included
alcohol pad to clean the mounting surface if necessary. Remove
the paper backing on the adhesive disc and rmly press in place.
Place the pedestal’s suction base (A) over the center of the
circular disc. While rmly holding the pedestal on top of the disc,
ip the base lever down (B) to the locked position.
Find a safe location on the interior of the vehicle’s windshield to
mount the pedestal. Firmly push the suction base (A) against
the windshield and ip the base lever down (B) to the locked
position. See diagram below.
Adjust the angle of the pedestal arm by tightening the angle
adjustment knob (C) at the base to the desired angle.
Connect iPhone Cradle to Pedestal
Connect the dual T-slots (D) on iPhone cradle to the dual T-tabs
(E) on the pedestal head. Adjust the angle and rotation of the
head by tightening the head adjustment knob (F).
Step 1.
F
iPhone Insertion and Removal from Cradle
Lift and hold the upper thumb tab (G) while gently lowering the
iPhone device (not included, sold separately) into the cradle.
Step 1.
G
B
A
A
B
C
(iPhone device
not included)
-
1
