Pacific Decor 55388.0 Operating instructions

ASSEMBLY INSTRUCTIONS AND PUMP INSTALLATION

Unpack the two porcelain parts of the fountain and the pump assembly.

The fountain bowl should be placed on a flat, level, stable surface.

Set the pump in the middle of the bowl. Place the open stem end of the ball over the pump and

connect the hose from the inside top of the ball to the stem at the top of the pump. Be sure the

electrical cord passes through the open area in the base of the ball and over the edge of the bowl.

The suction cups on the bottom of the pump will hold it in place on the bottom of the bowl.

Fill the bowl with water. It is important to have the pump covered by water at all times for the

pump to function properly and to avoid burning out the pump. Check the water level daily and

more often in hot, dry weather. Change water frequently to prevent build-up of minerals or algae.

Plug the pump into a 110 volt power outlet and enjoy. The pump pressure can be adjusted with

the dial on the front of the pump. Be sure the cord will not be accidently pulled or tripped on by

passers-by. Splashing could occur, especially at start up. Protect surrounding area. Do not handle

the plug with wet hands and keep out of reach of children and pets.

Replacement pump: #808

01/12

This manual is also suitable for

Download PDF