Parts:
-Part 1
-Part 4 : foamspacer for part 1
-part 2
-Part 5 foamspacer for part 2
-Part 3 (Metal Rod)
-Clean wall surface
-Remove protective film
1. Assemble the metal rod on part 2
2. Define where to install Part 2 (depending on the height of your freestanding stoves)
and mark as a reminder.
3. Use foamspacer (5) to pre-mark (with the finishing nail) the place where the plastic anchors will be installed
4. Install the plastic anchors
5. stick and strew foamspacers
6. stick part (2) to the wall and on top of foamspacer
7. during the time the glue is drying, use an adhesive tape to keep part (2) in place
8. Install foamspacer (4) under the range (leave a penny space)
9. Install part (1)
And there you go!
/
