Tripp Lite DWM3770PLX Owner's manual

1

Owner’s Manual

Portrait/Landscape Fixed

Flat Screen Wall Mount

MODEL: DWM3770PLX

CAUTION: DO NOT EXCEED MAXIMUM LISTED WEIGHT CAPACITY.

SERIOUS INJURY OR PROPERTY DAMAGE MAY OCCUR!

1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support

200 x 200

300 x 300

400 x 200

400 x 400

600 x 400

70”

MAX

110 lb.

(50 kg)

MAX

PROTECT YOUR INVESTMENT!

Register your product for quicker service

and ultimate peace of mind.

You could also win an ISOBAR6ULTRA

surge protector—a $100 value!

www.tripplite.com/warranty

Espanol 12 • Français 23 • Русский 34 • Deutsch 45

16-05-005-9335EC.indb 1 5/23/2016 4:43:27 PM

2

NOTE: Read the entire instruction manual before you start installation and assembly.

Warranty and Product Registration

WARNING

• Do not begin the installation until you have read and understood the instructions

and warnings contained in this manual. If you have any questions regarding any

of the instructions or warnings, please visit www.tripplite.com/support.

• This mounting bracket was designed to be installed and utilized ONLY as

speciﬁed in this manual. Improper installation of this product may cause damage

or serious injury.

• This product should only be installed by someone of good mechanical ability, with

basic building experience and a full understanding of this instruction manual.

• Make sure that the mounting surface can safely support the combined load of

the equipment and all attached hardware and components.

• If mounting to wood wall studs, make sure that mounting screws are anchored

into the center of the studs. The use of a stud ﬁnder is highly recommended.

• Always use an assistant or mechanical lifting equipment to safely lift and position

equipment.

• Tighten screws ﬁrmly, but do not over-tighten. Over-tightening screws can

damage the items, greatly reducing their holding power.

• This product is intended for indoor use only. Using this product outdoors could

lead to product failure and personal injury.

5-Year Limited Warranty

Seller warrants this product, if used in accordance with all applicable instructions, to be free from original defects

in material and workmanship for a period of 5 years from the date of initial purchase. If the product should

prove defective in material or workmanship within that period, Seller will repair or replace the product, in its sole

discretion.

THIS WARRANTY DOES NOT APPLY TO NORMAL WEAR OR TO DAMAGE RESULTING FROM ACCIDENT, MISUSE,

ABUSE OR NEGLECT. SELLER MAKES NO EXPRESS WARRANTIES OTHER THAN THE WARRANTY EXPRESSLY

SET FORTH HEREIN. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ALL IMPLIED WARRANTIES,

INCLUDING ALL WARRANTIES OF MERCHANTABILITY OR FITNESS, ARE LIMITED IN DURATION TO THE WARRANTY

PERIOD SET FORTH ABOVE; AND THIS WARRANTY EXPRESSLY EXCLUDES ALL INCIDENTAL AND CONSEQUENTIAL

DAMAGES. (Some states do not allow limitations on how long an implied warranty lasts, and some states do not

allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions

may not apply to you. This warranty gives you speciﬁc legal rights, and you may have other rights which vary from

jurisdiction to jurisdiction).

WARNING: The individual user should take care to determine prior to use whether this device is suitable, adequate

or safe for the use intended. Since individual applications are subject to great variation, the manufacturer makes

no representation or warranty as to the suitability or ﬁtness of these devices for any speciﬁc application.

PRODUCT REGISTRATION

Visit www.tripplite.com/warranty today to register your new Tripp Lite product. You’ll be automatically entered into a

drawing for a chance to win a FREE Tripp Lite product!*

* No purchase necessary. Void where prohibited. Some restrictions apply. See website for details.

Tripp Lite has a policy of continuous improvement. Speciﬁcations are subject to change without notice.

16-05-005-9335EC.indb 2 5/23/2016 4:43:27 PM

3

Component Checklist

IMPORTANT: Ensure that you have received all parts according to the component checklist prior to

installing. If any parts are missing or faulty, visit www.tripplite.com/support for service.

Wall Plate

4 mm Hex Key

Left Adapter Bracket

Right Adapter Bracket

Universal Plate

M6X10 (x4)

M5X14 (x4)

M8X30 (x4)

Anchor Bolt (x4) Concrete Anchor (x4)

M6X14 (x4)

Washer (x4)

M8X20 (x4)

Small Spacer (x8)

M6X30 (x4)

Big Spacer (x4)

D6 Washer (x4)

Package M

Package W

16-05-005-9335EC.indb 3 5/23/2016 4:43:27 PM

4

1a. Mount on Wood Stud Wall

3

Find and mark the exact

location of the mounting holes

Screw the wall

mount onto

the wall

Drill pilot holes

WARNING

• Make sure that mounting screws are anchored into the center of the studs.

Use of a stud ﬁnder is highly recommended.

• Installers are responsible to provide hardware for other types of mounting situations.

• Installers must verify that the supporting surface will safely support the combined

load of the equipment and all attached hardware and components.

Find a wood stud location for

mounting the wall mount

1

2

50 mm

(2”)

5 mm

3/16”)

Anchor Bolt

16-05-005-9335EC.indb 4 5/23/2016 4:43:28 PM

5

1b. Mount on Solid Brick or Concrete Block

WARNING

• When installing wall mounts onto a concrete masonry unit (also known as a CMU

or “cinder block”), verify that the actual concrete thickness is at least 35 mm

(1-3/8 inch) in order to hold the two concrete anchors. DO NOT DRILL INTO MORTAR

JOINTS! Be sure to mount the wall-mount plate with the included concrete anchors

and anchor bolts onto a solid section of the block. The solid sections can generally

be found 25 mm (1 inch) toward the middle of the block from either end. An electric

drill on a slow setting is suggested to drill the hole rather than a hammer drill so as

to avoid breaking out the back of the hole when entering a hollow section.

• Installers must verify that the supporting surface will safely support the combined

load of the equipment and all attached hardware and components.

Screw the wall

mount onto

the wall

Drill pilot holes

2

Find and mark the exact

location of mounting holes

1

Concrete Anchor

Anchor Bolt

60 mm

(2.4”)

10 mm

3/8”)

16-05-005-9335EC.indb 5 5/23/2016 4:43:29 PM

6

2. Installing the Adapter Brackets

2a. For Flat Back Screen

Top of the display

Washer

M5X14

M6X14

M8X20

16-05-005-9335EC.indb 6 5/23/2016 4:43:30 PM

7

Note: Choose appropriate screws, washers and spacers (if necessary) according to the screen type.

• Position the adapter brackets as close as possible to the center of the display.

• Screw the adapter brackets onto the display.

Do not over-tighten screws.

2b. For Recessed Back Panel or to Access A/V Inputs

or or or

Washer

Small

Spacer

Small

Spacer

M8X20

M6X30

M8X30

M6X30

M8X30

M6X30

M8X30

Small

Spacer

Small

Spacer

Big

Spacer

Big

Spacer

Washer

16-05-005-9335EC.indb 7 5/23/2016 4:43:31 PM

8

3. Installing the Universal Plate

Using M6X10 screws, D6 Washers and the 4 mm Hex Key, secure the Universal Plate to the adapter brackets.

4 mm

Hex Key

M6X10

D6 Washer

16-05-005-9335EC.indb 8 5/23/2016 4:43:32 PM

9

4. Hanging the Display onto the Wall Plate

Using an assistant or mechanical lifting equipment, lift the display with attached Universal Plate and slide the

Universal Plate into the mounted Wall Plate’s rail.

Note: For easier installation, slightly tilt the display horizontally with the Universal Plate facing upward.

Make sure the display is securely attached to the Wall Plate before releasing.

Wall Wall

16-05-005-9335EC.indb 9 5/23/2016 4:43:32 PM

10

5. Adjustment

Firmly hold the display’s upper edge and opposite lower edge and turn the display in the desired direction. The

pitching angle can be adjusted in 0°, 90°, 180° and 270° positions.

16-05-005-9335EC.indb 10 5/23/2016 4:43:33 PM

11

6. Removing the Display

To remove the display from the Wall Plate, turn the display to an incline position and lift upward and inward.

Note: Make sure the display’s rotation angle is in an incline position, NOT in a horizontal or vertical position.

Wall

Maintenance

• Check that the Wall Plate and brackets are secure and safe to use at regular intervals

(at least every three months).

• For any additional questions, visit www.tripplite.com/support.

1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support

16-05-005-9335EC.indb 11 5/23/2016 4:43:37 PM

12

Manual del Propietario

Soporte de Pared para

Pantalla Plana Fija Vertical /

Horizontal

Modelo: DWM3770PLX

PRECAUCIÓN: NO EXCEDA LA CAPACIDAD MÁXIMA DE CARGA INDICADA.

¡PUEDE OCURRIR UNA LESIÓN SEVERA O DAÑO A LA PROPIEDAD!

1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support

200 x 200

300 x 300

400 x 200

400 x 400

600 x 400

70 pulg.

MAX

50 kg

(110 lb. )

MAX

English 1 • Français 23 • Русский 34 • Deutsch 45

16-05-005-9335EC.indb 12 5/23/2016 4:43:38 PM

Page is loading ...

45

Benutzerhandbuch

Feste Hochformat-/

Querformat-Wandhalterung

für Flachbildschirme

MODELL: DWM3770PLX

ACHTUNG: DAS ANGEGEBENE MAXIMALGEWICHT DARF NICHT ÜBERSCHRITTEN WERDEN.

ES KÖNNEN SCHWERE KÖRPERVERLETZUNGEN ODER ERHEBLICHE SACHSCHÄDEN EINTRETEN!

1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support

200 x 200

300 x 300

400 x 200

400 x 400

600 x 400

70 Zoll (177.8 cm)

MAX

50 kg

MAX

English 1 • Espanol 12 • Français 23 • Русский 34

16-05-005-9335EC.indb 45 5/23/2016 4:43:58 PM

Page is loading ...

56

1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support

16-05-005 93-35EC_RevA

16-05-005-9335EC.indb 56 5/23/2016 4:44:02 PM

Tripp Lite DWM3770PLX Owner's manual

Tripp Lite DWM3770PLX Owner's manual

in other languages

Related papers

Other documents