American Electric Lighting Autobahn ATB0 Installation guide

Brand: American Electric Lighting

Model: Autobahn ATB0

Type: Installation guide

LEDIMPORTANTSAFETYINSTRUCTIONS

04/18/2023 IN-330





Toreducetheriskofdeath,personalinjuryorpropertydamagefromfire,electricshock,fallingparts,cuts/abrasions,and

otherhazardspleasereadallwarningsandinstructionsincludedwithandonthefixtureboxandallfixturelabels.



Beforeinstalling,servicing,orperformingroutinemaintenanceuponthisequipment,followthesegeneralprecautions.



Installationandserviceofluminairesshouldbeperformedbyaqualifiedlicensedelectrician.



Maintenanceoftheluminairesshouldbeperformedbyperson(s)familiarwiththeluminaires’constructionandoperation

andanyhazardsinvolved.Regularfixturemaintenanceprogramsarerecommended.



Itwilloccasionallybenecessarytocleantheoutsideoftherefractor/lens.Frequencyofcleaningwilldependonambient

dirtlevelandminimumlightoutputwhichisacceptabletouser.Refractor/lensshouldbewashedinasolutionofwarm

waterandanymild,non‐abrasivehouseholddetergent,rinsedwithcleanwaterandwipeddry.Shouldopticalassembly

becomedirtyontheinside,wiperefractor/lensandcleaninabovemanner,replacingdamagedgasketsasnecessary.



DONOTINSTALLDAMAGEDPRODUCT!Thisluminairehasbeenproperlypackedsothatnopartsshouldhavebeen

damagedduringtransit.Inspecttoconfirm.Anypartdamagedorbrokenduringorafterassemblyshouldbereplaced.



Recycle:ForinformationonhowtorecycleLEDelectronicproducts,pleasevisitwww.epa.gov.



Theseinstructionsdonotpurporttocoveralldetailsorvariationsinequipmentnortoprovideeverypossiblecontingency

tomeetinconnectionwithinstallation,operation,ormaintenance.Shouldfurtherinformationbedesiredorshould

particularproblemsarisewhicharenotcoveredsufficientlyforthepurchaser’sorowner’spurposes,thismattershouldbe

referredtoAcuityBrandsLighting,Inc.



READANDFOLLOWALLSAFETYINSTRUCTIONS!

SAVETHESEINSTRUCTIONSANDDELIVERTOOWNERAFTERINSTALLATION



Disconnectorturnoffpowerbefore

installationorservicing.

Verifythatsupplyvoltageiscorrectby

comparingitwiththeluminairelabel

information.

Makeallelectricalandgrounded

connectionsinaccordancewiththeNational

ElectricalCode(NEC)andanyapplicable

localcoderequirements.

Allwiringconnectionsshouldbecapped

withULapprovedrecognizedwire

connectors.

WARNING

RISKOFELECTRICSHOCK



Allowlamp/fixturetocoolbeforehandling.

Donottouchenclosureorlightsource.

Donotexceedmaximumwattagemarkedon

luminairelabel.

Followallmanufacturer’swarnings,

recommendationsandrestrictionsfor:driver

type,burningposition,mounting

locations/methods,replacementand

recycling.

WARNING

RISKOFBURN



Wearglovesandsafetyglassesatalltimes

whenremovingluminairefromcarton,

installing,servicingorperforming

maintenance.

Avoiddirecteyeexposuretothelightsource

whileitison.

CAUTION

RISKOFINJURY



Keepcombustibleandothermaterialsthat

canburn,awayfromlamp/lens.

Donotoperateincloseproximitytopersons,

combustiblematerialsorsubstances

affectedbyheatordrying.

CAUTION

RISKOFFIRE

LEDIMPORTANTSAFETYINSTRUCTIONS

04/18/2023 IN-330



 Neverconnectcomponentsunderload.

 Donotmountorsupportthesefixturesinamannerthatcancuttheouterjacketordamagewire

insulation.

 Unlessindividualproductspecificationsdeemotherwise:NeverconnectanLEDproductdirectlytoa

dimmerpacks,occupancysensors,timingdevices,orotherrelatedcontroldevices.LEDfixturesmustbe

powereddirectlyoffaswitchedcircuit.

 Unlessindividualproductspecificationsdeemotherwise:Donotrestrictfixtureventilation.Allowfor

somevolumeofairspacearoundfixture.AvoidcoveringLEDfixtureswithinsulation,foam,orother

materialthatwillpreventconvectionorconductioncooling.

 Unlessindividualproductspecificationsdeemotherwise:Donotexceedfixturesmaximumambient

temperature.

 Onlyusefixtureinitsintendedlocation.

 LEDproductsarePolaritySensitive.EnsureproperPolaritybeforeinstallation.

 ElectrostaticDischarge(ESD):ESDcandamageLEDfixtures.Personalgroundingequipmentmustbe

wornduringallinstallationorservicingoftheunit.

 DonottouchindividualelectricalcomponentsasthiscancauseESD,shortenlamplife,oralter

performance.

 Somecomponentsinsidethefixturemaynotbeserviceable.Intheunlikelyeventyourunitmayrequire

service,stopusingtheunitimmediatelyandcontactanABLrepresentativeforassistance.

 Alwaysreadthefixturescompleteinstallationinstructionspriortoinstallationforanyadditionalfixture

specificwarnings.



Please see product specific installation instructions for additional warnings or any applicable FCC or other regulatory

statements.

Failure to follow any of these instructions could void product warranties. For a complete listing of product Terms and

Conditions, please visit www.acuitybrands.com.

OurBrandsIndoor/OutdoorIndoorLightingOutdoorLightingControls

LithoniaLightingGothamAmericanElectricLightingDARKTOLIGHT

CarandiniMarkArchitecturalLightingAntiqueStreetLampsLightingControl&Design

HolophanePeerlessHydrelROAM

RELOCRenaissanceLightingTersenSensorSwitch

WinonaLighting Synergy

AcuityBrandsLighting,Inc.assumesnoresponsibilityforclaimsarisingoutofimproperorcarelessinstallationorhandlingofitsproducts.

ABLLEDGeneralWarnings,FormNo.503.203



©2013AcuityBrandsLighting,Inc.Allrightsreserved.6/12/13

CAUTION:RISKOFPRODUCTDAMAGE

04/18/2023 IN-330 Rev E



ATB0 External House Side Shield

and Light Trespass Shield Accessories Installation and

Maintenance

Manual

INTRODUCTION

Product Description

The following External House Side Shield accessories

are available on the ATB0 series.

This component is designed for tool-less installation

utilizing two latches over the top of the luminaire.

These shields are not to be used with factory installed

House Side Shield (HSS) options.

External House Side Shields

Part Number Description

ATB0P20XR2R3LR5HSS ATB0 EXTERNAL HOUSE SIDE

SHIELD P20X R2 OR R3L OR R5

ATB0P20XR3R4HSS ATB0 EXTERNAL HOUSE SIDE

SHIELD P20X R3 OR R4

ATB0P30XR2R3LR5HSS ATB0 EXTERNAL HOUSE SIDE

SHIELD P30X R2 OR R3L OR R5

ATB0P30XR3HSS ATB0 EXTERNAL HOUSE SIDE

SHIELD P30X R3

ATB0P30XR4HSS ATB0 EXTERNAL HOUSE SIDE

SHIELD P30X R4

ATB0P45XR2R3LR5HSS ATB0 EXTERNAL HOUSE SIDE

SHIELD P45X R2 OR R3L OR R5

ATB0P45XR3HSS ATB0 EXTERNAL HOUSE SIDE

SHIELD P45X R3

INSTALLATION

Tools and Materials Required

None (Hand installable)

External House Side Shield:

Align text “SHIELD SIDE”, located on the underside

of the External House Side Shield, with the rear

of the luminaire. Note that this part can only be

assembled as shown in Figure 1, with “SHIELD

SIDE” oriented to the rear of the luminaire. Place

the two latches on the shield assembly over the top

edges of the ATB0 Luminaire housing, as shown in

Figure 2. Press down on the latches individually to

engage the External House Side Shield securely.

Figure 1 – ATB0 External House Side Shield, Pre- Installation

______________________________________



Figure 2 – Shield/latch Installed

Figure 3 –SHIELD SIDE Label

“SHIELDSIDE”

04/18/2023 IN-330 Rev E



INTRODUCTION

PRODUCT DESCRIPTION

The following Universal Light Trespass Shield accessories

are available for the ATB0 series and are intended to limit

light directed on the opposing street side or directly behind

the luminaire (house side).

These components are designed for tool-less installation

utilizing two latches over the top of the luminaire.

These shields are not to be used with factory installed House

Side Shield (HSS) options.

Universal Light Trespass Shields

Part Number Description

ATB0ULTS ATB0 UNIVERSAL LIGHT

TRESPASS SHIELD

INSTALLATION

Tools and Materials required

None (Hand Installable)

Universal Light Trespass Shield

House Side Orientation:

Align the Universal Light Trespass Shield, with the rear of

the luminaire, as shown in Figure 5. Place the two latches

on the shield assembly over the top edges of the luminaire

housing, as shown in Figure 4. Press down on the latches

individually to engage the Universal Light Trespass Shield

securely.

Street Side Orientation:

Align the Universal Light Trespass Shield, with the front of

the luminaire, as shown in Figure 6. Place the two latches

on the shield assembly over the top edges of the luminaire

housing, as shown in Figure 4. Press down on the latches

individually to engage the Universal Light Trespass Shield

securely.

Contractor Resources:

Check out helpful programs,

tools, installation videos and more!

Figure5–ATB0ULTSOrientedHouseSide

Figure4–Shield/LatchInstalled

Figure6–ATB0ULTSOrientedStreetSide

American Electric Lighting Autobahn ATB0 Installation guide

American Electric Lighting Autobahn ATB0 Installation guide

American Electric Lighting Autobahn ATB0 Installation guide

Other documents