NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
CAUTION
RISK OF PERSONAL INJURY
OR PROPERTY DAMAGE.
• Do NOT abuse glass doors by striking or slamming shut
• Never operate the fireplace without the barrier in place
• While the barrier prevents direct contact with hot glass, be aware
that the metal frame may get hot and can cause burns if touched.
• Please review the warnings and operating instructions that came
with your fireplace. If you do not have the instructions a copy may
be downloaded at IHP.us.com.
WARNING
HOT GLASS WILL CAUSE BURNS.
DO NOT TOUCH GLASS UNTIL COOLED.
NEVER ALLOW CHILDREN TO TOUCH GLASS.
• Install only when fireplace is OFF and COLD.
• Fireplace surfaces get EXTREMELY HOT!
• The glass on the front of the fireplace reaches EXTREMELY HIGH
temperatures and can cause severe burns if touched. Even after
the gas is turned off, fireplace surfaces remain extremely hot.
• Keep children away from an operating fireplace. Closely supervise
children in any room where a fireplace is operating to prevent
contact with glass.
NOTE: This barrier kit is designed to fit fireplaces manu-
factured prior to January 1, 2015.
KIT CONTENTS
• Barrier
• Adaptors (2 upper, 3 lower)
• Bag of 16 Screws
• These Instructions
REQUIRED TOOLS
• #3 Phillips screwdriver
• 5/16” hex screwdriver
HEARTH PRODUCTS
SUPPLEMENTAL INSTRUCTIONS
INSTALLATION INSTRUCTIONS FOR LINEAR BARRIER RETROFIT KITS
ON ASTRIATM RHAPSODY AND SIRIUS AND SUPERIORTM DRL6300 AND DRL3000 GAS FIREPLACES
LINEAR BARRIER RETROFIT KITS
P/N 900420-00
REV. A 02/2015
P900420-00
INSTALLING THE BARRIER
1) Using a #3 Phillips screwdriver, remove the three screws at the bottom
of the glass door enclosure panel, tilt the enclosure awau from the unit
at the base, lift away, and set the panel aside.
NOTE: If your fireplace has a modesty panel that hides the screws from
view, remove this panel first.
2. Using a 5/16” hex head nut driver, install the two upper mounting
brackets.
3. Using a 5/16” hex head nut driver, install the three lower mounting
brackets.
Figure 1: Affixing an upper bracket
Figure 2: Upper and lower bracket locations
NOTE: When properly adjusted for depth, the barrier should prevent
someone from reaching between the barrier and the fireplace face
and touching the glass. If necessary, adjust the barrier using the
provided adaptors to prevent any direct contact with the glass.
4. Following the procedure outlined in the installation manual, replace the
glass enclosure panel and secure it with the three black screws that
were removed in Step 1. Please note that unless the door is properly
installed over the mounting flange at the top of the firebox, it will be
very difficult to fully close the door.
5. Slide the barrier frame mounting brackets over the fireplace brackets
and adjust to the proper depth. Secure the bracket with the screws
provided in the kit.
6. Install the front frame and barrier and fasten to the mounting brackets
using the screws provided.
Figure 3: Securing the Barrier
1508 Elm Hill Pike, Suite 108
Nashville, TN 37210
IHP.US.com
-
1
Astria Fireplaces Sirius Instruction Sheet
- Type
- Instruction Sheet
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Astria Fireplaces SIRIUS42TEN Assembly And Installation Instructions
-
-
-
-
-
-
-
-
-
Other documents
-
Superior Fireplaces DRT4000 Operating instructions
-
-
-
-
-
-
-
-
Superior DRL3042TEP Installation And Operation Instructions Manual
-