2. Cumberland
  3. Editor/Navigator Repair Label

Cumberland Editor/Navigator Repair Label Owner's manual

  • Hello! I've reviewed the instructions for applying the repair label to HIRED-HAND EV3000 and EV3001 controllers. This document provides important steps for surface preparation, label alignment, and preventing accidental setting changes during application. I'm here to assist you with any specific questions you might have about the process or the controllers.
  • What should be done before applying the repair label?
    What is the most important step in applying the repair label?
    When is the alignment easier?
    What should be done to prevent accidental setting changes?
Editor/Navigator Repair Label
for
EV3000 and EV3001 Controllers
HIRED-HAND • 1759 County Rd 68 • Bremen, Alabama 35033 · Phone 256-287-1000 • Fax 256-287-2000
Part No. 4802-0162 rev 9-2012 Page 1 of 1
IMPORTANT!
Alignment of the indicator viewing windows
is the most important first step.
Alignment is easier when most of the
indicators are ON.
Apply the label first to the viewing window
area then apply sweeping pressure (top to
bottom) to work the label gradually outward
one side at a time.
Turn power off before wiping across the
Editor buttons to prevent accidental setting
changes.
IMPORTANT!
SURFACE PREPARATION:
Ensure the label surface is clean and dry before applying the
repair label.
Remove dust and dirt from the label surface. DO NOT use
harsh cleaners.
To remove surface oils and improve adhesion, the surface
must be wiped clean with plain rubbing alcohol and wiped dry.
Do Not apply the label to a wet or damp surface.
IMPORTANT!
Prevent excessive contact with the adhesive on the back
side of the label.
4501-6151
Repair
Label
/