2. ExperTexture
  3. 3033

ExperTexture 3033 Operating instructions

  • Hello, I'm a chat assistant that has reviewed the instructions for the ETX Texture Gun. I understand the document provides guidance on proper usage, including shaking the cartridge, attaching, spraying, and cleaning. I'm ready to assist with any questions you have regarding the instructions and the device.
  • How long should I shake the cartridge before use?
    What is the recommended distance from the wall when spraying?
    How do I clear the gun after use?
    How to clean cartridge after use?
    What should I use to maintain the gun?
Professional Texture Gun and Cartridge Instructions
Directions
1. Shake cartridge for atleast 20-30 seconds, make certain
contents of cartridge are over 70F degrees.
2. Attach cartridge to the ETX Texture Gun by inverting gun and
placing collar into gun. Turn in a clockwise motion until snug.
3. Spray by turning the gun right side up and pulling the trigger.
Distance from wall should be 18-24 inches. For best results, test
in an inconspicuous location such as scrap drywall or a
cardboard sheet to achieve the desired pattern.
Clearing
1. Clear by inverting gun and cartridge, spray for 2-3 seconds into
trash can or receptacle.
2. Remove cartridge by turning in a counter-clockwise motion. After
use, rinse cartridge valve under running water, shake off excess.
Use the ETX Gun Cleaner (sold separately) after each use to
clean and lubricate all internal components of the ETX Texture
Gun.
/