2. TNVTEC
  3. 2023
2023

TNVTEC 2023 User guide

  • I have reviewed the provided user manual for the smartBox-xxxx adapter. This document outlines the steps for updating the adapter's firmware via a WiFi connection. The manual explains how to connect to the device's network, access the update page, and monitor the update status using the indicator light.
  • How do I connect to the WiFi network?
    What is the IP address for the update?
    How do I know the update is complete?
Firmware Update
1. Both USB Power Charger
&USB data port of car unit
can be used for upgraded
online OTA.
2. Turn on Wi-Fi and join the
network 'smartBox-xxxx',
enter the password with
'88888888'
3.Open Safari & enter IP
address '192.168.1.101';
Sliding down the page &
press 'Update'.
4. The White light will flash
once the upgrade start up.
The upgrade is complete
when the light goes from
blinking to always on.
5. Forget this 'smartBox-
xxxx' Network after the
upgrade finished.
smartBox
interface. A
new version
will be
displayed
on the right
bottom.
6. Replug the adapter to
car data port. It will show
'smartBox-xxxx' with new
version.
NOTE! Please don't remove the activator until the light stop
flashing. Otherwise, it will get damaged!
/