2. HANECO
  3. PANNELLO
PANNELLO

HANECO PANNELLO Installation guide

  • Hello! I've reviewed the HANECO LIGHTING LED Panel Installation Guide for PANNELLO-LV and PANNELLO-LV-AR models. This document outlines the necessary steps for both embedded and suspended ceiling installations, and specifies the various power and color temperature options available. I'm ready to answer your questions about these LED panels.
  • Who should install this luminaire?
    What should be done before installation?
    What happens if the product is not installed correctly?
PANNELLO
Thanks for choosing our PANNELLO LED troer.
We strongly recommend that you read this inatallation guide carefully before installation.
For ceiling embedded installation
Product Specifications
PRODUCT CODE SAP CODE FEATURE CCT POWER LUMEN NET
WEIGHT
PANNELLO-LV
PANNELLO-LV-AR
2001975
2001976
Tritone + Power
Switchable
3000K
4000K
5000K
26W
2760lm
2910lm
2870lm
3.1kg
32W
3330lm
3560lm
3470lm
36W
3630lm
3900lm
3810lm
40W
3820lm
4090lm
3950lm
HANECO LIGHTING LED PANEL INSTALLATION GUIDE
Dimensions
Installation Instructions
For more information
www.haneco.com.au
1300 001 LED (533)
V16112022 PAGE 1
The luminaire must be installed by a professional electrician. Switch power o prior to installation. Ensure input voltage
conforms to the voltage range of product. Ensure wires are securely connected. Before switching on, ensure that all
the wiring is correct. The warranty is void if product is not installed according to the below instructions.
Please read these instructions carefully before using this product and keep for future reference.
WARNING
47.5mm
1195mm
295mm
1. Remove existing decorative ceiling
board where the desired installation
will be.
2. Toggle the dip switch at the back
of the luminaire to the required
colour temperature setting, and then
connect the input and output power
cord properly.
3. Put the luminaire in place. 4. Installation is now complete.
PANNELLO
HANECO LIGHTING LED PANEL INSTALLATION GUIDE
For more information
www.haneco.com.au
1300 001 LED (533)
V16112022 PAGE 2
For ceiling suspended installation
Installation Instructions
1. Ensure you have the complete list of accessories
required for suspended installation.
4. Thread the screws through accessory holes into
the ceiling and use a screwdriver to fix it into the
rubber plugs.
7. Installation is now complete.
2. Drill four holes as specified in the illustration.
5. Install the luminaire: hook up two hooks at the
lower part in the hole on the steel frame. Adjust
left and right pendant cord at Y-shape end to make
centred. Then use hexagon wrench to tighten the
screw at the bottom.
3. Using a hammer, beat the four rubber plugs into the
four holes.
6. Connect AC input wire, toggle the dip switch at
the back of the luminaire to the required colour
temperature setting, and then connect the input and
output power cord properly.
/