If the mobile device that is paired with the S113 BT speaker is a cellular phone you can:
Ÿ Answer Call: one quick press of the multifunction button .
Ÿ End Call: one quick press of the multifunction button .
Ÿ Reject Call: pressing and holding the multifunction button for three seconds or until you hear a tone that indicates this function has been
completed.
Ÿ Voice Recognition: If supported by your mobile device, turn the voice recognition feature on, in standby mode press and hold the
multifunction button for three seconds; a tone will sound to indicate activation. Say the name of who you would like to call and wait for
the dial tone.
Ÿ Transferring call between speaker and phone: during a call press and hold the multifunction button for three seconds until you hear a
tone. The same can be done to transfer the call from your phone to the S113 BT speaker.
Ÿ Mute Microphone: press and hold the until the tone sounds, this indicates that the function has completed.
Ÿ Redial: in standby mode, press and release the multifunction button twice in succession.
Ÿ
Ÿ Volume down: one short press of the
Ÿ Next track: while music is playing, press and hold the until the track moves to the next track.
Ÿ Previous track: while the music is playing, press and hold the until the start of the track replays. Quickly press and hold the again to
go to the previous track.
Ÿ Pause / Play: one short press and release of the multifunction button
Volume up: one short press of the
Notes:
Ÿ Pairing mode will last up to five minutes or until a device is found.
Ÿ If you exceed the effective range of approx. 10M (33ft) the speaker will disconnect and will automatically reconnect if the speaker re-enters
the effective range within ten minutes.
LED Light Signals
Blue
Ÿ Blue light flashing means the speaker device is on and not paired.
Ÿ Blue light flashing every five seconds means speaker is paired to a device.
Red
Ÿ Red light flashing means battery is low
Ÿ Red light on constantly means charging
Red & Blue
Ÿ When both the red and the blue lights are rapidly flashing, it means the speaker is searching for device to pair with.
No part of this manual including the products described in it, may be reproduced, transmitted, stored in a retrieval system, or translated into
any language in any form or by any means, except documentationkept by the purchaser for backup purpose, without the express written
permission of ARCTIC (HK) Ltd. In no event shall ARCTIC its directors or employees be liable for any indirect damages, incidental or
consequential damages arising from any defect or error in this manual or product.
2013 ARCTIC (HK) Ltd. All Rights Reserved.
ARCTIC Switzerland AG
www.arctic.ac
For Android (Ice Cream Sandwich & Jelly Bean)
Press Menu > Settings > Switch on Bluetooth > Bluetooth > Search for devices > S113 BT > Pair
ON
ON
ON
ON
OFF
C. Connect via 3.5mm Cable
1. Turn on the S113 BT speaker by sliding the power button
2. Insert one end of the 3.5mm audio cable into the speaker and the other end into your mobile device headphone's output
3. Volume up: one short press of the
4. Volume down: one short press of the
5. Play music
6. Phone functions on the speaker are not available when connected via cable.
Phone Operations
Music Operations
