King Canada KM-044 User manual

Brand: King Canada

Model: KM-044

Type: User manual

King Canada KM-044: Enhance your milling and drilling operations with our safety guard, designed to protect you from rotating tools and flying debris. Constructed with durable materials, this guard ensures long-lasting performance and reliable protection in your workshop. Its transparent design allows for clear visibility of the cutting area, ensuring precision and control during your projects.

KING CANADA INC. DORVAL, QUÉBEC, CANADA H9P 2Y4

www.kingcanada.com

SAFETY GUARD FOR

MILLING/DRILLING MACHINES

2-YEAR LIMITED WARRANTY FOR KING INDUSTRIAL PRODUCTS

PROOF OF PURCHASE

Please keep your dated proof of purchase for warranty and servicing purposes.

LIMITED TOOL WARRANTY

King Canada makes every effort to ensure that this product meets high quality and durability

standards. King Canada warrants to the original retail consumer a 2-year limited warranty as of the

date the product was purchased at retail and that each product is free from defects in materials.

Warranty does not apply to defects due directly or indirectly to misuse, abuse, normal wear and

tear, negligence or accidents, repairs done by an unauthorized service center, alterations and lack

of maintenance. King Canada shall in no event be liable for death, injuries to persons or property

or for incidental, special or consequential damages arising from the use of our products.

To take advantage of this limited warranty, return the product at your expense together with your

dated proof of purchase to an authorized King Canada service center. Contact your retailer or visit

our web site at www.kingcanada.com for an updated listing of our authorized service centers. In

cooperation with our authorized serviced center, King Canada will either repair or replace the

product if any part or parts covered under this warranty which examination proves to be defective

in workmanship or material during the warranty period.

Model KM-044

Designed for King Milling/Drilling Machines

Models KC-35, KC-45 & KC-40HC

ASSEMBLY

AND INSTALLATION

Figure 1

Assembly Instructions

Locate the pivot support assembly (A) Fig.1 and slide it onto the guard shaft (B),

this assembly can only be done by sliding it onto the bottom end of the guard

shaft, it will not fit onto the top end. Then to secure it, tighten set screw (C) using

a 2.5mm hex. key. Fix the transparent guard (D) to the guard shaft with 2 small

cap screws (E) using a 4mm hex. key.

Installation Instructions

This safety guard is designed for use with King Milling/Drilling Machines models

KC-35, KC-45 and KC-40HC and should be installed to the left side of the head

casting. If your Milling/Drilling Machine does not have the necessary mounting

holes, it will be necessary to drill and tap holes into the head casting. To do this,

you will need an electric drill, a size 10 drill bit and a 6mm x 1.0 Hand Tap. Drill

and tap approximately 3/8” (15mm) deep holes following the drilling position

schematics on the 2 following pages, then mount the pivot support “L” shaped

plate (F) to the head casting with the 2 round head hex. screws using a 4mm hex. key.

HOLE POSITIONS

SCHEMATIC

KC-35

HOLE POSITIONS

SCHEMATIC

KC-45 & KC-40HC

King Canada KM-044 User manual

King Canada KM-044 User manual

King Canada KM-044 User manual

Related papers