iCT220, iCT250

Ingenico iCT220, iCT250 Initial Setup

  • Hello! I am an AI chatbot trained to assist you with the Ingenico iCT220, iCT250 Initial Setup. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Sircle POS
Ingenico iCT220
Initial Setup of the iCT220
Plug the power cable from the device into the network hub, then plug the
network hub into a power outlet.
Plug an Ethernet cord into the network hub where its labeled “ETH”.
Once the device powers on click “F” on the device to bring up the “Telium
Manager”.
Enter your stock password which should be 1234567 and the “F” key.
Click 0, 2, 4, 1, 1, scroll down to “hardware infos” then click “Ethernet”. Write
down your IP address since we will be using this later for the Sircle POS setup.
Page 1 of 3
Setup with Sircle POS
Open the POS software and click settings, then “Payment Processing”.
Uncheck “Express Checkout” if selected, and open “Other Payment
Processing”.
In the drop down menu select “velocityemc” and enter your “Merchant Profile ID”
along with your state initials.
Page 2 of 3
Once completed, hit the back button on your tablet until you are back at the
initial settings screen.
Select “Payment Device Setup”, then select “Ingenico iCT250/iCT220”.
Enter the IP address that you wrote down earlier from your Ingenico iCT220,
and type 6200 for the port number.
Page 3 of 3
/