Use the dust cover to protect the Intermec computer keypad
from dust, dirt, and rain. The clear material of the dust cover
allows you to use the touch screen and the keypad with the dust
cover installed. You cannot install a dust cover if you are using a
serial adapter, CAC reader, or holster accessory.
To install the dust cover
1 If you have a CK31G, CN2, or 751G, remove the serial port
cover.
2 Insert the top of the CK31, CK31G, CN2, 751G, or CK61G
into the dust cover.
3 Pull the dust cover over the bottom of the handheld
computer.
Installing the Dust Cover: Each Intermec computer has a unique dust
cover made specifically for it. This illustration shows the CK31 with a
52-key keypad dust cover for reference.
Note: Remove the dust cover before inserting your
computer into a charging or communications dock.
Dust Cover Instructions
A
B
4 If necessary, install the serial port cover on your computer.
Installing the Serial Port Cover
Note: On the CK61G you may also need to insert the
head phone plug into the jack as shown in the
following illustration.
Dust cover
Dust cover
Dust cover
CK31 serial port
cover (CK31G only)
CN2 serial
port cover
751G serial
port cover
Installing the Head Phone Plug
Headphone
jack
Dust Cover Instructions
*074130-003*
P/N 074130-003
Worldwide Headquarters
6001 36th Avenue West
Everett, Washington 98203
U.S.A.
tel 425.348.2600
fax 425.355.9551
www.intermec.com
©
2007 Intermec Technologies
Corporation. All rights reserved.
-
1
-
2
-
3
-
4
Intermec 751G Operating instructions
- Type
- Operating instructions
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Intermec 074490 Datasheet
-
-
-
Intermec CN2A Quick start guide
-
-
-
-
-
Intermec CK31 User manual
-