Architectural Lighting Works LightPlane 11 Recessed Installation guide
- Type
- Installation guide
LightPlane 11 Recessed
Installation Instructions
Tel: (510) 732-1794 Fax: (650) 249-0412 web: www.archltgworks.com
11
16
"
7
3
4
"
8"
12
5
8
"
1.
• Wings run behind Gypsum Board.
• Suspend with 1/4-20 Threaded Rod and
nuts in rear holes.
• Connect to Framing.
2.
• Run Electrical Conduit to fi xture
through 1/2” Knockout
• Remove Access Cover
• Make electrical connections, reattach
access cover.
Finial Nut
3.
Threaded Rod
Electrical Conduit
Framing
Ceiling
(installed after fi xture)
“Wings”
Access Cover
• Connect sections if necessary.
• Use 8-32 Fasteners
8
7
8
"
Gypsum Board Ceilings T-Bar Ceilings
• Parrallel T-Bar should be spaced 8-7/8”.
• T-Bar Brackets center & support fi xture on T-Bar.
• Tie off Hanger Wire to Wire Hanger Brackets.
T-Bar Brackets
Wire Hanger Brackets
LIGHTPLANE 11 RECESSED
Install Instructions
Tel: (510) 732-1794 Fax: (650) 249-0412 web: www.archltgworks.com
4.
Sheetmetal screws
Receptacle
Fill and finish trimless edge.
5.
• Connect Module Plugs into Receptacles.
• Swing Modules into recessed channel (after ceiling installation).
Plug
• For stability, fasten drywall to Wings.
• Fill, tape, sand and paint trimless edge.
LIGHTPLANE 11 RECESSED
Install Instructions
Tel: (510) 732-1794 Fax: (650) 249-0412 web: www.archltgworks.com
-
1
-
2
-
3
