2. Architectural Lighting Works
  3. LightPlane 11 Recessed

Architectural Lighting Works LightPlane 11 Recessed Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Architectural Lighting Works LightPlane 11 Recessed Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
LightPlane 11 Recessed
Installation Instructions
Tel: (510) 732-1794 Fax: (650) 249-0412 web: www.archltgworks.com
11
16
"
7
3
4
"
8"
12
5
8
"
1.
• Wings run behind Gypsum Board.
• Suspend with 1/4-20 Threaded Rod and
nuts in rear holes.
• Connect to Framing.
2.
• Run Electrical Conduit to fi xture
through 1/2” Knockout
• Remove Access Cover
• Make electrical connections, reattach
access cover.
Finial Nut
3.
Threaded Rod
Electrical Conduit
Framing
Ceiling
(installed after fi xture)
“Wings”
Access Cover
• Connect sections if necessary.
• Use 8-32 Fasteners
8
7
8
"
Gypsum Board Ceilings T-Bar Ceilings
• Parrallel T-Bar should be spaced 8-7/8”.
• T-Bar Brackets center & support fi xture on T-Bar.
• Tie off Hanger Wire to Wire Hanger Brackets.
T-Bar Brackets
Wire Hanger Brackets
LIGHTPLANE 11 RECESSED
Install Instructions
Tel: (510) 732-1794 Fax: (650) 249-0412 web: www.archltgworks.com
4.
Sheetmetal screws
Receptacle
Fill and finish trimless edge.
5.
• Connect Module Plugs into Receptacles.
• Swing Modules into recessed channel (after ceiling installation).
Plug
• For stability, fasten drywall to Wings.
• Fill, tape, sand and paint trimless edge.
LIGHTPLANE 11 RECESSED
Install Instructions
Tel: (510) 732-1794 Fax: (650) 249-0412 web: www.archltgworks.com
/