CY3655-EXT enCoRe™ II DEVELOPMENT KIT
QUICK START GUIDE
Unpack the CY3655-EXT enCoRe II DVK
contents.
Insert 40-pin DIP foot on to the application board.
Align the enCoRe II pod over the DIP foot.
To connect button S1 to P0.2 place a jumper
on J11. To connect button S2 to P0.3 place a
jumper on J16. To power the application
board by VBUS place a jumper at J5.
Go to Control Panel > Mouse > Pointer
Options; uncheck “Enhance Pointer Precision”
option. Open a drawing application such as
Paint.
Connect B side of the USB A/B cable to the
CY3655-EXT enCoRe II Application board and
the A side to the PC. The DrawUSB example
enumerates on the PC as a USB Mouse HID
device in Device Manager.
Press the S1 button on the board; the cursor
moves in the shape of letters U, S, B. Press the
S2 button to toggle the left mouse button.
